HOME MERIDIAN 155-A309-016-064 Setup guide

Page 1Page 8
Model: 155-A309-016-064
Setup and Operation Guide
Comfort Lift Chair
• NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired
compliance could void user's authority to operate the equipment.
-A309-016-064
DS
Residential Use Only Residential Use Only

Page 7Page 2
TABLE OF CONTENTS
Important Safety Information .................................................................................3
Fabric Care...............................................................................................................4
Assembly Of Your Lift Chair
Transformer and Cord Connections ......................................................................4
Attaching the Chair Back to the Chair Base .........................................................4
Operating Your Lift Chair
Raising the Chair.................................................................................................5
Lowering the Chair..............................................................................................5
Reclining the Chair..............................................................................................5
Lock and Unlock the Hand Control....................................................................5
Heat Function Operation.....................................................................................6
Massage Function Operation .............................................................................6
Note:
protection such as an area rug or furniture pads. Area rugs and padding not included
with purchase.
Wiring plugs are not
connected correctly
according to the
illustration on page 4
(20 minutes)
plugs
correctly
Restart the handset by
turning off and back on
plugs
correctly
plugs
correctly
Residential Use Only Residential Use Only
Trouble Shooting .....................................................................................................7

Page 6
INTENSITY
MASSAGE
WAVE STDY PULSE
HEAT
HEAT(ON/OF)
USB
INTENSITY SETTINGS
MASSAGE SETTINGS
How to Use the Massage Function
Press the INTENSITY + button once to active the massage function.
Press the INTENSITY -button to low intensity, then press - again to off
massage
Press the MASSAGE or button to go to the three available massage
setting: WAVE, STEADY, or PULSE. Each setting is indicated by a COLORED LED
light. The massage function will automatically shut off after30 minutes of
continuous use.
How to adjust the intensity of the massage function
Press the INTENSITY + or - button to set the massage intensity to one of three
available settings: LOW, MEDIUM or HIGH. Each setting is indicated by aCOLORED
LED light.
How to Use the Heat Function
To turn on or off the heat function, press the HEAT button. There is only one
setting for the HEAT function, on or off.
NOTE: Heat & Massage system is designed with an auto-shutoff mechanism that
turn off after 0 minutes of use. It is recommended the heat and massage units not
be used for more than 0 minutes at a time.
Residential Use Only Residential Use Only
IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING YOUR LIFT CHAIR.
WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
DANGER: To reduce the risk of electric shock - Always unplug this
furnishing from the electrical outlet before cleaning.
Do not stand directly in front of chair when lowering the lifted chair to the
seated position, continuing to hold the down arrow will allow the footrest
to raise potentially causing the user to lose their footing.
Unplug from outlet before putting on or taking off parts.
Close supervision is necessary when used by or near children, or
disabled people.
Use this furnishing only for its intended use as described in these
instructions. Do not use attachments not recommended by themanufacturer.
Never operate this furnishing if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped in water.
Never operate the furnishing with the air openings blocked. Keep the air
openings free of lint, hair, and other obstacles.
Keep the cord away from heated surfaces.
Never drop or insert any object into any opening.
Do not use outdoors. Just for household indoor use only.
Do not operate where aerosol (spray) products are being used or where
oxygen is being administered.
To disconnect, turn all controls to the off position, then remove plug
from outlet.
WARNING: Risk of injury - Keep children away from extended foot support.
WARNING: Risk of injury to Persons - do not use this furnishing to
support video equipment such as televisions or computer monitors.
Maximum weight limit not to exceed more than 350 pounds.
When not in use, it is recommended that the wand be stored securely in
the pocket on the outside of the arm。
WARNING: Continuing to hold the up Arrow will lift the chair.
WARNING: Continuing to hold the down Arrow will raise the Footrest
For loading always put heavier items at the bottom and not near the top
in order to help prevent the possibility of the furnishing tipping over.
SAVE THESE INSTRUCTIONS.
SERVICING OF DOUBLE-INSULATED PRODUCTS.
In a double-insulated product, two systems of insulation are provided instead
of grounding. No grounding means is provided on a double-insulated
product, nor is a means for grounding to be added to the product. Servicing a
double-insulated product requires extreme care and knowledge of the
system, and is to be done only by qualified service personnel. Replacement
parts for a double-insulated product must be identical to the parts they
replace.

Page 5
Sitting in your lift chair
Press and hold the UP button to raise your lift chair to the standing position.
Back into the lift chair and sit in the center of the seat, using the armrests for
support if needed.
Press the DOWN button to lower the lift chair to a comfortable seated position.
Reclining the lift chair
Press and hold the DOWN button until comfortably reclined.
Press and hold the UP button to return to an upright position. Release the button
when the lift chair reaches a comfortable seated position.
Standing from your lift chair.
Press and hold the UP button to raise your lift chair.
Release the button when the lift chair reaches a height where you can stand
up comfortably.
OPERATING YOUR LIFT CHAIR
Page 4
FABRIC CARE INSTRUCTIONS
CORD AND TRANSFORMER CONNECTIONS
Connect the massage unit from the back to
the plug marked BACK.
Connect the heat unit from the back to the
plug marked HEAT.
BACK
HEAT
The transformer and the power cable are in
a foam bag located on top of the chair.
Connect to the plug coming from the seat.
Transformer
and cable
INTENSITY
MASSAGE
WAVE STDY PULSE
HEAT
INTENSITY
MASSAGE
WAVE STDY PULSE
HEAT
HEAT(ON/OF)
USB
INTENSITY SETTINGS
MASSAGE SETTINGS
Residential Use Only Residential Use Only
WARNING: Continuing to hold the down Arrow will raise the Footrest.
WARNING: Continuing to hold the up Arrow will lift the chair.