Homebase 632681 User manual

INSTRUCTION MANUAL
IMPORTANT: Please read these instructions before using the product. Retain instructions for future use.
HHGL Limited, MK9 1BA; HHGL (ROI) Limited, D02 X576
Requires 1 x 10W max. LED E27 GLS bulb
(bulb not included)
DIDSBURY
PEWTER
TABLE LAMP

Diagram shown for illustration purposes only - product may differ slightly from the one shown above
This product should be disposed of responsibly at the end of its life. Please recycle
where facilities exist. Check with your local authority or retailer for recycling advice.
(Waste Electrical and Electronic Equipment Directive)
4
1
2
4
5
3
ASSEMBLY
Take care not to trap any wiring when
screwing sections together.
Step 1 Insert stem into the base.
Step 2 Secure the stem by tightening the
2 grub screws.
Step 3 Place the base felt on the underside
of the lamp base.
Step 4 Carefully attach the shade and
secure in place using the shade
ring onto each lamp holder.
Step 5 Insert a light bulb into the
lamp holder.
Requires 1 x 10W max. LED
E27 GLS bulb. (not included)
Selecting the correct bulb:
Maximum wattage – 10 Watt LED.
Bulb shape – GLS.
Bulb cap shape – E27.
Do not exceed the maximum wattage or use a different shape of bulb. This may cause your light
fitting to overheat.
GENERAL INFORMATION
Clean only with a soft, dry cloth.
Do not use polishes or abrasive cloths.
Not suitable for use in bathrooms.