Homebase EDALE User manual

INSTRUCTION MANUAL
IMPORTANT: Please read these instructions before
using the product and retain for future use.
HHGL Limited, MK9 1BA
HHGL (ROI) Limited, D02 X576
EDALE
1 LIGHT
FLOOR LAMP
Diagrams shown for illustration purposes only - product may dier slightly from the ones shown overleaf.
This product should be disposed of responsibly at the end of its life.
Please recycle where facilities exist. Check with your local authority
or retailer for recycling advice.
(Waste Electrical and Electronic Equipment Directive)

SAFETY AND CARE ADVICE
This product has been designed for non-professional, domestic use only.
Dispose of all packaging components correctly and responsibly and in accordance with all local laws and
regulations. Never leave packaging components within reach of children, as they can be a source of danger.
Before inserting or replacing a bulb, ensure the power is switched o and the bulb has cooled down.
Do not modify any product before or after installation. This may render the product unsafe.
WARNINGS
This product is not intended for use by persons (including children) with reduced physical, sensory and
mental capabilities, or lack or experience and knowledge, unless they have been given supervision or
instruction concerning the use of the product by persons responsible for their safety.
Children should be supervised to ensure that they do not play with the product.
Do not place this fitting in a damp atmosphere.
CARE AND MAINTENANCE
Always disconnect the power supply when servicing or cleaning.
Use a clean, soft, dry or slightly damp cloth for cleaning this product.
Do not use abrasive cloths or polishes, as this may cause damage to the product.
CHANGING BULBS
This product requires 1 x 10W max. E27 LED GLS bulb (bulb not included).
Ensure that the power supply has been disconnected and the bulb has cooled down before replacing.
PARTS LIST
Floor lamp x 1
Glass shade x 1
ASSEMBLY
Step 1 Screw Upper stem onto the angle arm assembly.
Step 2 Scre Lower stem onto the upper stem.
Step 3 Taking care not to trap any wiring, screw the stem assembly onto the base.
Step 4 Carefully screw the shade onto the lamp holder. Take care not to over tighten.
Step 5 Insert the bulb into the lampholder.
Step 1
Step 2
Step 4
Step 5
Step 4
Step 3