Homebase NAOMI User manual

HHGL Limited, MK9 1BA
HHGL (ROI) Limited, D02 X576
INSTRUCTION MANUAL
IMPORTANT: Please read these instructions before
using the product and retain for future use.
NAOMI
TABLE LAMP

SAFETY AND CARE ADVICE
• For your safety, this product must be installed in accordance with local building regulations. If in any
doubt, or where required by law, consult a competent person who is registered with an electrical
self-certication scheme. Further information is available online or from your local authority.
• This product has been designed for non-professional, domestic use only.
• Dispose of all packaging correctly and responsibly and in accordance with all local laws and regulations.
Never leave packaging components within reach of children, as they can be a source of danger.
• Before inserting or replacing a bulb, ensure the power is switched o and the bulb has cooled down.
• Do not modify or alter any product before or after installation. This may render the product unsafe.
• This is a Class 2 product and does not require an earth connection.
• Always shut o the power to the circuit before starting installation.
WARNINGS
• This product is not intended for use by persons (including children) with reduced physical, sensory and mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning the use of the product by persons responsible for their safety.
• Children should be supervised to ensure that they do not play with the product.
• Do not place this tting in a damp atmosphere.
CARE AND MAINTENANCE
• Always disconnect the power supply when servicing or cleaning.
• Use a clean, soft, dry or slightly damp cloth for cleaning this product.
• Do not use abrasive cloths or polishes, as this may cause damage to the product.
CHANGING BULBS
• This product require 1 x E27 (ES) Golf ball LED bulb 7W max.
• Ensure that the power supply has been disconnected and the bulb has cooled down before replacing.
IMPORTANT!
• If the external exible cable or cord of this luminaire is damaged, it should only be replaced by a
qualied person.
PARTS LIST
Pre-wired tting x 1
Glass shade x 1
Shade ring x 1

Step 2
1. Place the glass shade over the lamp holder.
2. Re-screw the shade ring to secure glass shade in
place.
Step 1
Remove the shade ring from the lamp holder.
1
2

Step 4
1. Remove the plug cap and insert the plug into a
normal household socket.
2. Using the in-line switch, switch on and test the
tting.
Step 3
Screw the bulb (not supplied) into the lamp holder,
making sure you don’t exceed the bulb wattage stated
on the product.
1
2