HOMEDEPOT L-PG096PAL User manual

Assembly Instructions
Long Island Pergola
Item: L-PG096PAL

short supporting
beam(1)
A
2
short supporting beam
(2)
B
2
supporting beam joint
C
4
long supporting beam
D
4
connector
E
4
beam（1）
F
4
beam（2）
G
6
beam（3）
H
4
beam（4）
I
6
beam joint
J
10
post cover
K
4
decoration ring
L
8
post
M
4
stake
N
4
stake cover
O
4
cover board
P
4
cover board
Q
1
fixing piece
R
12
Parts List

AA
M6*15 bolt
56PCS
BB
M6 flat washer
76 PCS
CC
M6*95 bolt
20 PCS
EE
M6 wrench
2 PCS
Hardware Pack 1

AA
M6*15 bolt
24 PCS
BB
M6 flat washer
24 PCS
Hardware Pack 2
Fig.1: Attach connector (E) onto short supporting beam(1) (A) (short supporting beam(2) (B)); place
supporting beam joint (C) onto middle of short supporting beam(1) (A) and short supporting beam(2) (B),
then lock and tighten with bolt (AA) and flat washer (BB). Move connector (E) to the middle, lock and
connect onto short supporting beam(1) (A) and short supporting beam(2) (B); assemble long supporting
beam (D) in the same way.
Fig.2: Lock and tighten the assembled short supporting beam and long supporting beam with bolt (AA)
and flat washer (BB) to form a rectangle frame.
Fig.3: Place beam joint (J) onto middle of beam(1) (F) (beam(2) (G)) and beam(3) (H) (beam(4) (I)), and
move it to an appropriate position; then make them connected with bolt (AA) and flat washer (BB).
Fig.4: Lock the assembled beams onto the assembled supporting beams with bolt (CC) and flat washer
(BB).

Fig.5: Spread and place a cover board (P) onto beam, then place fixing piece onto cover board (P), lock
and tighten with bolt (AA) and flat washer (BB), do not fix another side.
Fig.6: Spread and place another cover board (P) onto beam, separate and tighten it with assembled
cover board by using bolt (AA) and flat washer (BB), do not fix another side at first. Tighten all the bolts
finally.
Hardware Pack 3
AA
M6*15 bolt
64 PCS
BB
M6 flat washer
64 PCS
FF
Φ8*180 peg
16 PCS

Fig.7: Attach stake cover (O) and decoration ring (L) onto post (M), then lock and tighten stake (N) and
post (M), decoration ring (L) with bolt (AA) and flat washer (BB); assemble post cover (K), decoration ring
(L) onto post (M) in the same way.
Fig.8: Uplift the assembled top with posts supported underneath, then connect and tighten short
supporting beam(1) (short supporting beam(2)), long supporting beam (D) and the assembled top with bolt
(AA) and flat washer (BB).
Fig.9: Uplift stake cover (O), then fix the assembled pergola onto ground with peg (FF).