8 9
ENEN
EN
EN
1. Clean your skin and remove the hair on the surface of the
skin. You may use tweeze, wax, shave, etc. Do not use the
epilator accessory on your face as it is not designed for
facial use.
2. Use white eyeliner to conceal areas that should not be
treated such as the edges of your lips and facial moles.
3. Ensure you are in a well lighted area when performing
your treatment.
4. Turn on your device and select the rst level on the
base unit, which is Low. Put on the provided eye goggles or
sunglasses.
With A Face Adaptor
5. Remove the accessory protective cap and connect the
face adaptor. The face adaptor will allow the me to emit
only single pulses with the desired energy level.
6. Press the cartridge activation button on the
applicator to turn on the applicator. Gently position the
applicator on the area you want to treat. Press once the
activation button to emit a single pulse.
7. Reposition the applicator on the next area to be treated
and press the activation button again to emit another
pulse. Repeat these previous steps until you have covered
the entire facial area. Wait at least 10 seconds before you
treat over the same spot.
Without A Face Adaptor
5. Press the activation button on the applicator to
turn on the applicator. Gently position the applicator on
the area you want to treat. Upon contact - a pulse will be
emitted. Remove the applicator after a single pulse.
7
1
5
2
4
4
get your professionally smooth skin
For best results, use me on the same area once a week for the rst 7 times.
Performing additional maintenance treatments, after the rst 7 treatments, will
help your hair removal results last longer.
* If you feel that the hair is too noticeable, you can treat that specic area every 2 days.
treatment durations
For effective results, should be used according to the treatment times indicated
below.
The minimum treatment times recommended below may vary from person to
person. We recommend to see that each treatment area is covered by 2-3 pulses:
When treating the face, use me twice a week for 2 weeks.
Then perform additional treatments every two weeks to help results last longer.
1st week
2nd week 3 rd week 4 th wee k 5 th wee k 6 t h week
as
required
1st week 2nd week
3rd week 5th week 7th week
4th week 6th week 8th week
Note: Without the face adaptor the system will emit continuous pulses,
handling must be very cautious and following the instructions
Note: For men it is not advisable to treat the beard as it might create
uneven results, which may produce changes in facial characteristics that
may not be desirable
Note: Always start with LOW level. If you feel comfortable, you may
increase the level for better results
6. Reposition the applicator on the next area to be treated, another pulse will
be emitted, remove the applicator after a single pulse. Repeat these previous
steps until you have covered the entire facial area. Wait at least 10 seconds
before you treat over the same spot.
