Homestead Night Stand with 3 Drawers User manual

Page 1 of 7
Night Stand with 3 Drawers
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
• Check you have all the components and
tools listed on the following pages.
• Remove all fittings from the plastic bags
and separate them in to their groups.
• Keep children and animals away from the
work area, small parts could choke if
swallowed.
• Make sure you have enough space to
layout the parts before starting.
• During assembly do not stand or put
weight on the product, this could cause
damage.
• Assemble the item as close to its final
position (in the same room) as possible.
• Assemble on a soft level surface to avoid
damaging the unit or your floor.
• Parts of the assembly will be easier with 2
people.
• Make sure that all the objects are
removed before moving the assembled
unit.
• Do not stand on the product, this could
cause damage.
• Do not fully tighten nuts and bolts until all
nuts and bolts are partially tightened.
• Do not over tighten nuts and bolts to avoid
causing damage to the threading.
• Do not use power tools to assemble your
furniture. Power tools may strip or
damage the parts.
Care and maintenance
• Only clean using a damp cloth and mild detergent, do no use bleach or abrasive cleaners.
• From time to time check that there are no loose screws on this unit.
Handy Hints
• Two people will be required to assemble this unit.
• Assemble all parts and bolts loosely during assembly, only once the product is complete should
you fully tighten the bolts
• Regularly check and ensure that all bolts and fittings are tightened properly.
• Have the following tools close at hand.

Page 2 of 7
PART LIST:
Top
A
Qty. 1
Front Frame
B
Qty. 1
Back Frame
C
Qty. 1
Side Panel
D
Qty. 2
Bottom Stretcher
E
Qty. 2
Upper Stretcher
F
Qty. 6
Lower Floor
G
Qty. 1
Front Drawer
H
Qty. 3
Drawer Floor
I
Qty. 3
Side Drawer 1
J
Qty. 3
Side Drawer 2
K
Qty. 3
Back Drawer
L
Qty. 3

Page 3 of 7
HINT: Do not fully tighten screws in this step.
HARDWARE LIST:
Assembly: Cabinet
Step 1 Step 2
Joint Connector Screw
1
Qty. 8
Screw (Short)
2
Qty. 24
Screw (Long)
3
Qty. 3
Screw (Long)
4
Qty. 3
Wood Dowel
5
Qty. 6
Wood Plug
6
Qty. 8
Allen Wrench
7
Qty. 1

Page 4 of 7
Fully tighten all screws at this time.
Assembly: Cabinet (Continue)
Step 3 Step 4
Step 5 Step 6

Page 5 of 7
Assembly: Cabinet (Continue)
Step 7 Step 8
Assembly: Drawer
Step 1 Step 2

Page 6 of 7
Locking the Drawer
Assembly: Drawer (Continue)
Step 3 Step 4
Assembly: Cabinet and Drawer
Step 1 Step 2

Page 7 of 7
Finish Product
Weight Limits:
This unit has been designed to support the
maximum loads shown. Exceeding these load
limits could cause sagging, instability, product
collapse, and/or serious injury.
110.0 lbs (50.0 kg)
Drawer 22.0 lbs
(10.0 kg)
Drawer 22.0 lbs
(10.0 kg)
Drawer 22.0 lbs
(10.0 kg)