Honeywell MS9520 Voyager User manual

How to install the Honeywell (formerly Metrologic) Voyager Scanner
This article covers the steps required to install the Voyager wand scanner for use with the Web
Kiosk or Point of Sale (POS) terminal within the ClubReady system
Requirements:
1. Admin rights on the computer you are installing the scanner on
2. An availible USB port on the computer or powered USB Hub.
3. Access to the notepad application on your computer to test the scanner after install.
Step 1 - Verifying you have the correct scanner
Please verify the scanner matched the information listed below. If anything does not match
these instructions will not work for installing your scanner. This may also mean ClubReady will
not support or only be able to provide limited support for your scanner.
Manufacturer: Honeywell (formerly Metrologic)
Model Name: Voyager
Model Number: MS9520
Part Number: MK9520-32A38
Once you have verified all of the information above is correct, please continue to the next step.
How to install the Honeywell (formerly Metrologic) Voyager Scanner - 1

Step 2 - Plug scanner USB cable into an availible usb port.
1. Log into computer with an account that has admin rights. This is necessary for the scanner to install
correctly on this computer.
2. Plug the scanner's usb cable into an availible USB port on the computer or a powered USB hub.
3. Please wait a few minutes for the scanner to configure, most windows systems will display a
notification in the lower-right corner of the screen near the time letting you know that it is configuring a
device.
How to install the Honeywell (formerly Metrologic) Voyager Scanner - 2

Step 3 - Testing the scanner in Notepad
To test the scanner please perform the following actions:
Windows XP:
1. Click the start button in the lower-left corner of the screen and select Run from the meny that appears
2. A dialog box will appear, type notepad and click the OK button
3. Click in the notepad window to make sure it is the active window.
4. Scan a barcode off of a membership card, bottle of water, energy bar, etc.
5. Like the picture above, you should see the number that is listed under the barcode of the item you
scanned show up in notepad.
Windows Vista and Windows 7:
1. Click the start button in the lower-left corner of the screen
2. In the search field please type in notepad and select it from the list that appears
3. Click in the notepad window to make sure it is the active window.
4. Scan a barcode off of a membership card, bottle of water, energy bar, etc.
5. Like the picture above, you should see the number that is listed under the barcode of the item you
scanned show up in notepad.
If you see the barcode number appear in notepad you have successfully configured the scanner for use
within ClubReady. If you have any questions please contact us for assistance.
How to install the Honeywell (formerly Metrologic) Voyager Scanner - 3