Honeywell HCM-890WTG User manual

OWNER’S MANUAL
High
Low
Off
2.0 GALLON (7.6 LITERS)
OUTPUT PER DAY*
NATURAL COOL MOISTURE
™
HUMIDIFIER
*Output dependent on room temperature and humidity.
Model HCM-890 Series
HU4075.01 HCM890/890C OM Eng 6/14/01 3:07 PM Page 1

When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
electric shock, and injury to persons, including the
following:
1. Always place this humidifier on a firm, flat and level surface. This humidifier
may not work properly on an uneven surface.
2. Place this humidifier in an area where it is not accessible to children.
3. Do not place the humidifier near any heat sources such as stoves,
radiators, and heaters.
4. Before using the humidifier, check the power cord for any signs of damage.
If the cord is found to be damaged, DO NOT USE and return the humidifier
to the manufacturer under the warranty agreement for repair.
5. This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of shock, this plug is intended to fit only one way in a
polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified electrician. DO NOT attempt to
defeat this safety feature.
6. To disconnect the humidifier, first turn controls to the OFF position, then
grip the plug and pull it from the wall outlet. Never pull by the cord.
7. A loose fit between the AC outlet (receptacle) and plug may cause
overheating and a distortion of the plug. Contact a qualified electrician to
replace loose or worn outlet.
8. The humidifier should always be unplugged and emptied when not in
operation or while being serviced or cleaned.
9. Never tilt or attempt to move the humidifier while it is operating or filled with
water. UNPLUG the humidifier before moving.
10. This humidifier requires regular cleaning. Refer to the CLEANING
instructions provided. Never clean the humidifier in any manner other than
as instructed in this manual.
11. Turn the humidifier OFF if the relative humidity exceeds 60%, or if you
notice moisture on the inside of your windows. For proper humidity reading
use a hygrometer, which is available in many hardware and department
stores or by ordering one from the manufacturer (see Care Products).
IMPORTANT SAFETY
INSTRUCTIONS
READ AND SAVE THESE SAFETY
INSTRUCTIONS BEFORE USING
THIS HUMIDIFIER
HU4075.01 HCM890/890C OM Eng 6/14/01 3:07 PM Page 2

Thank you for purchasing a Honeywell Natural Cool Moisture™ humidifier. If
you would like more information on our full line of products please visit our
website at: www.honeywell.com/yourhome.
HOW DOES IT WORK?
Natural Cool Moisture™ System
The fan pulls dry air through a wet filter and releases invisible moisture into the
air. When the unit is running you will not see or feel a “mist”. You will know
your humidifier is putting moisture into the air as you watch the water level in
your tank decrease throughout the day.
The Honeywell®exclusive Automatic Moisture Balance System™ increases
moisture output when the air is dry and lowers the moisture output when
the humidity level is high. This automatically helps to adjust the output for
maximum comfort and helps prevent condensation.
MODEL HCM-890
Your humidifier is made up of the following parts:
NATURAL COOL
MOISTURE™FILTER
RINSE-TO-CLEAN®
BASE
FILL CAP
WATER
TANK
High
Low
Off
MOTOR HOUSING
INTRODUCTION
HU4075.01 HCM890/890C OM Eng 6/14/01 3:07 PM Page 3

NOTE: We recommend that the humidifier be disinfected prior to first use.
Please see CLEANING instructions.
• Select a firm, level, flat location — at least six inches (15 cm) from any wall
for proper air flow (Fig. 1).
• Place the humidifier on a water-resistant surface, as water can damage
furniture and some flooring. Honeywell will not accept responsibility for
property damage caused by water spillage.
• Remove the water tank by grasping the handle and pulling straight up
(Fig. 1).
• Lift up on the Motor Housing to remove and set aside (Fig. 2). Remove the
Natural Cool Moisture™ filter from the base before filling the unit with
water. Soak in a sink full of cool water to help reduce mineral build up and
place back in the humidifier while wet. DO NOT SQUEEZE OR WRING
OUT THE NATURAL COOL MOISTURE™ FILTER. To help extend the life of
your filter repeat this step each time you fill your humidifier.
• Turn the water tank upside down so that the fill cap is facing up; unscrew
the fill cap by turning it counter-clockwise and set aside.
• Fill the water tank with COOL tap water (Fig. 3). Distilled water is not
necessary as the water is filtered by the Natural Cool Moisture™ filter.
DO NOT USE HOT WATER. Doing so may damage the humidifier.
• Replace the fill cap by turning it clockwise . DO NOT OVER TIGHTEN.
Turn the water tank right-side up.
Fig. 1
Wall
6”
Lift
Fig. 2 Fig. 3
SET UP
FILLING
HU4075.01 HCM890/890C OM Eng 6/14/01 3:07 PM Page 4

NOTE: WHEN CARRYING THE FILLED WATER TANK, PLEASE USE THE HANDLE
AND PLACE YOUR OTHER HAND UNDER THE TANK FOR ADDITIONAL
SUPPORT.
• Place the Motor Housing back onto Rinse-to-Clean™ Base.
• Once the filled tank has been positioned, do not attempt to move the
humidifier. If it has to be moved, unplug the humidifier and remove the
water tank first.
NOTE: DO NOT POUR WATER INTO THE GRILL ON THE TOP OF THE MOTOR
HOUSING. DOING SO MAY DAMAGE THE HUMIDIFIER OR CAUSE
PERSONAL INJURY.
CAUTION: DO NOT PLUG IN THE HUMIDIFIER WITH WET HANDS AS AN
ELECTRIC SHOCK COULD OCCUR.
POWER
• With the power switch in the OFF position, plug the filled humidifier into a
polarized 120V outlet. DO NOT FORCE THE POLARIZED PLUG INTO THE
OUTLET; it will only fit one way.
HUMIDITY CONTROL
1. Set the fan speed control to the desired position
(Fig. 4).
HIGH: For fast humidifying
LOW: For quieter operation
NOTE: The length of time your humidifier runs will
vary depending on the quality of construction
and insulation of your room and house, as well as the fan speed.
2. Turn the humidifier OFF if the humidity level feels too moist or you notice
condensation forming on the walls and/or windows.
ALWAYS be sure to empty any unused water in the Rinse-to-Clean™ Base
and/or Water Tank each time you refill the water tank or finish using the
humidifier.
High
Low
Off
Fig. 4
FILLING CONTINUED
OPERATION
HU4075.01 HCM890/890C OM Eng 6/14/01 3:07 PM Page 5

We recommend cleaning the humidifier once a week, more often if you have
hard water or notice a build up of impurities or detect unpleasant odors.
NOTE: THE USE OF OTHER WATER TREATMENT PRODUCTS MAY
DAMAGE THE FILTER OR HUMIDIFIER.
Cleaning involves two steps SCALE REMOVAL and DISINFECTING. Be sure to
perform these in the proper order to avoid harmful chemical interactions.
• First, turn off and unplug the humidifier.
• Remove the Water Tank and Motor Housing.
•Remove the Natural Cool Moisture™ filter from the Rinse-to-
Clean™ Base.
• Discard any residual water from the Base.
• Clean all outside surfaces with a dry, soft cloth. DO NOT USE WATER.
THIS MAY DAMAGE THE HUMIDIFIER OR CAUSE ELECTRIC SHOCK.
STEP ONE:
SCALE REMOVAL
RINSE-TO-CLEAN™ BASE
1. Fill the Rinse-to-Clean™ Base with
either:
• one cup (8 ozs, 250 ml) of
undiluted white vinegar
OR
• DuraRinse™ Humidifier
Cleaner, part no. AC-816,
following bottle instructions
2. Let solution stand for 20 minutes
3. With the vinegar or DuraRinse™ in
the Rinse-to-Clean™ Base clean all
interior surfaces with a soft cloth or
brush to help remove scales.
4. Rinse the Rinse-to-Clean™ Base
thoroughly with water to remove
scale and cleaning solution.
STEP TWO:
DISINFECTING
WATER TANK
1. Fill the water tank with:
• 1 teaspoon of household bleach
• 1 gallon (4 L) of water.
Pour some of this solution into the
Rinse-to-Clean™ Base.
2. Let solution stand for 20 minutes.
3. Rinse with water until the odor of
bleach is gone.
NOTE: Remove filter before cleaning
Failure to remove the filter during cleaning will destroy the filter
WEEKLY CLEANING
HU4075.01 HCM890/890C OM Eng 6/14/01 3:07 PM Page 6

NOTE: DO NOT ATTEMPT TO CLEAN THE NATURAL COOL MOISTURE™
FILTER WITH ANY CHEMICAL SOLUTIONS, DOING SO WILL DAMAGE THE
FILTER.
• If the Natural Cool Moisture™ filter appears to be clogged by hard water or
mineral deposits, soak it in a sink full of cool water for 10 minutes. DO NOT
SQUEEZE OR WRING OUT THE NATURAL COOL MOISTURE™ FILTER.
Always place it back in the humidifier wet.
There are many steps you can take each time you fill your humidifier to make
sure you get the most life out of our Natural Cool Moisture™ filter.
1.To prevent mineral deposits use DuraFree™ Humidifier Descaler Water
Softener, part no. AC817, each time the Water Tank is refilled.
2.Treat the Natural Cool Moisture™ filter with care. DO NOT squeeze or wring
it out, DO NOT clean the filter using any chemical solution.
3.Always purchase Honeywell Brand Natural Cool Moisture™ filters as the fan
motor of this humidifier and the Natural Cool Moisture™ filter are designed
to function efficiently as a set. Using any other filter could damage the motor
or impair the humidifier’s performance.
4.Be sure to empty water from the Water Tank and Base when not in use.
PROLONGING THE LIFE OF THE FILTER AND
MAINTAINING A CLEAN HUMIDIFIER
HU4075.01 HCM890/890C OM Eng 6/14/01 3:07 PM Page 7

Q: I hear the fan turning, but I don’t see any mist. Is my humidifier operating
properly?
A: Dry air is pulled through the Cool Moisture system and a fan disperses
invisible, moisture balanced air. There is no “mist” emitted. When operating
normally you will feel only cool air coming from the unit. Monitor the water
level in your tank/base. If you notice a decrease in the water tank over 24
hours then the unit is operating normally.
Q: My unit has been running for several hours. I hear the fan spinning, but I
do not notice the water level in the tank decreasing.
A: First, check the moisture pad to be sure it is wet. If the pad appears dry,
remove it from the base and gently rinse under cool water. Reposition wet
filter in the base. You may also want to check the current moisture level in
your home. If the humidity level is over 60%, the unit will not put out much
moisture as your air is already saturated.
• Follow weekly CLEANING instructions when the humidifier will not be used
for at least one week or more, or at the end of the season.
• At the end of the season, remove and throw away the filter; do not store with
a used filter.
• Dry the humidifier completely before storing. DO NOT store with water
inside the Base or Water Tank.
• Pack the unit in its original carton and store in a cool, dry location.
• Before next use, remember to install a new filter and clean the humidifier.
END-OF-THE-SEASON CARE AND STORAGE
TROUBLE SHOOTING
HU4075.01 HCM890/890C OM Eng 6/14/01 3:07 PM Page 8

This product is rated at 0.6 amps, 120V, 60 Hz.
NOTE: IF YOU EXPERIENCE A PROBLEM WITH YOUR HUMIDIFIER PLEASE SEE
THE WARRANTY INSTRUCTIONS. PLEASE DO NOT ATTEMPT TO OPEN OR
REPAIR THE HUMIDIFIER YOURSELF. DOING SO WILL VOID THE WARRANTY
AND COULD CAUSE DAMAGE TO THE UNIT OR PERSONAL INJURY. IF THE
PROBLEM PERSISTS PLEASE CONTACT THE CONSUMER SERVICE CENTER.
Mail questions or comments to:
Honeywell
Consumer Service Center
250 Turnpike Road
Southborough, MA 01772 USA
Please be sure to specify model number.
Call us toll-free at:
1-800-332-1110
Or visit our website at:
www.honeywell.com/yourhome
ELECTRICAL RATINGS
CUSTOMER ASSISTANCE
HU4075.01 HCM890/890C OM Eng 6/14/01 3:07 PM Page 9

If your local dealer is out of stock, Honeywell replacement parts and care products
may be ordered directly. You can call 1-800-332-1110 to order with a MasterCard,
Visa or Discover or fill out the form below and mail it along with a check or money
order (sorry no COD’s accepted) to:
Honeywell
Consumer Service Center
250 Turnpike Road
Southborough, MA 01772 USA
Please allow four to six weeks for delivery.
Massachusetts residents please add 5% Sales Tax.
Item Item No. Qty. US CAN Total
Natural Cool Moisture™ Filter, one per pack AC888 $ 9.99 $13.50
DuraSept®Humidifier Bacteriostatic Treatment (32 oz., 1L) AC802 5.00 6.75
DuraFree®Humidifier Water Softener (32 oz., 1L) AC817 5.00 6.75
DuraRinse®Humidifier Cleaner (32 oz. 1L) AC816 5.00 6.75
Rinse-to-Clean Base HCM890-1 10.00 13.50
Water Tank and Fill Cap HCM890-2 19.99 27.00
Fill Cap HCM890-3 5.00 6.75
Digital Hygrometer and Thermometer (F°/C°) HAC555 19.99 27.00
SUBTOTAL
MA Residents add 5% Sales Tax/CAN residents only add 7% GST
Shipping and Handling (US residents add $4.95/CAN residents add $7.00)
TOTAL ENCLOSED
Name Check or Money Order Enclosed
Address Credit Card No.
Exp. Date
Day Time Phone Signature
Measure room temperature and humidity level. Free standing
can be used anywhere in the room. Display Temperature.
PRICE
03
050100
DRYCOMFORTDAMP
%
CARE PRODUCTS
HU4075.01 HCM890/890C OM Eng 6/14/01 3:07 PM Page 10