
PRO DUNK® ASSEMBLY INSTRUCTIONS
(~Day 5)
7. Loosen the top four 16mm J-Bolt Hex Nuts (M) from the 16mm Anchor J-
Bolts (L). Leave Anchor Footing Template (N) in place.
8. Put the 16mm Anchor J-bolt Washers (W) on each Anchor J-Bolt (L).
9. Place the Vertical Post (A) down over the footing making sure not to
damage the 16mm Anchor J-Bolts (K) threads. Using the 16mm J-Bolt
Gusseted Hex Nuts With Built-In Washer (Y), bolt down Vertical Post (A)
finger tight with two metal ears on the Vertical Post (A) to the rear.
10.Level the Vertical Post (A) by adjusting the 16mm J-Bolt Hex Nuts (M)
located underneath the flanged base plate of the Vertical Post (A). Then
tighten top 16mm J-Bolt Gusseted Hex Nuts With Built-In Washer (Y)
against the top side of the flanged base plate of the Vertical Post (A).
11.Slide the Main Extension Arm (B) over the top of the Vertical Post (A) and
attach to the lower pivot tube with a 16mm X 31cm Hex Bolt (I) and a
16mm Lock Nut (K).
12.Slide the hole located in the Rim Height Indicator (U) over one of the
second set of welded tubes on the Main Extension Arm (B). Attach the
Spring-Assist Cartridge (E) to the second set of attachment holes on both
the Main Extension Arm (B) and Vertical Post (A) welded tabs utilizing a
16mm X 31cm Hex Bolt (I) and a 14mm X 13cm Hex Bolt (G) as shown in
figure A.1. Tighten each with a 14mm Lock Nut (H). The Rim Height
Indicator (U) should now hang freely along side the Spring-Assist
Cartridge (E).
13.Next attach the Crank Adjustment Cylinder (F) using a 16mm X 31cm Hex
Bolt (I) at the top and a 14mm X 13cm Hex Bolt (G) at the bottom. Tighten
each with a 16mm Lock Nut (K) and 14mm Lock Nut (H). Next, remove
and discard the blue plastic spreader tube from Spring-Assist Cartridge
(E).
14.Attach Parallel Linkages (C) to Vertical Post (A) with a 16mm X 28cm Hex
Bolt (J) and a 16mm Lock Nut (K).
NOTE: It does not matter which end of the
parallel link you attach to the vertical post.
CAUTION: Injury may occur if linkages are
allowed to fall off main arm during assembly.
15.[THIS STEP HAS ALREADY BEEN DONE DURING REASSEMBLY]
Next, lay the H-Frame Backboard Mount (D) down into backboard aligning
the four top and bottom holes in the H-Frame Backboard Mount (D) with
the four holes in the top and bottom of the backboard (see figure D).
Check to make sure the rim hole pattern in the H-Frame Backboard Mount
(D) lines up with the rim hole pattern in the backboard, adjust as needed.
6