Hoover Insight User manual

6
1. Cleaner asseMBlY
A. Handle Assembly
B. Nozzle Assembly
C. Wand with Handle Grip and Hose
D. Cleaner Body
E. Extension Cord
F. Instruction manual
Remove all parts from carton and identify
each item shown.
Make sure all parts are located before
disposing of packing materials.
Carton Contents
WARNING
! !
To reduce the risk of electric shock,
unplug before cleaning or servicing.
attaCh Main BodY to nozzle
1.2 Place the nozzle on a flat surface with
the neck (A) and the support lever (B) in the
upright locked position.
1.3 Hold the bag housing vertically and
place over neck and support lever.
1.4 Push firmly down until the bag housing
locks in place
1.5 Push the end of the nozzle hose (C) into
the opening on the bottom of the bag hous-
ing (D) until it clicks into place.
1.1
A
B
C
D
E
F
1.2 AB1.3
1.5
C
D
1.4

7
1.12 This cleaner is equipped with a Quick-Change power cord (A).
To connect the extension cord to the Quick-Change power cord,
plug the socket end of extension cord into the 3-prong end of the
Quick-Change cord.
When completed, plug extension cord into properly grounded outlet
to operate. If extension cord is damaged during use, simply replace
with new extension cord (see Extension Cord Guideline on page 5).
1.11 Make sure the crevice tool (A) and
upholstery tool (B) are in their designated
places on the back of the machine.
attaCh hose
position tools
attaCh handle
1.6 Lift the handle lock button up and
place the handle assembly down into the
opening on top of the bag housing as far
as it will go.
1.7 When the handle assembly has been
pushed down as far as it can go, press the
handle lock back down. As a precaution,
pull up on handle to confirm it has been
locked properly.
1.8 Hold wand with handle grip and hose at
a slight angle as you slide bottom end of
wand into channel on back of bag housing.
1.9 As you are lowering the wand down into
the channel, align the indicator graphic on
the handle grip with the indicator graphic
on the channel in the bag housing.
1.10 Push the opposite end of the hose (A)
into the opening in the top of the cleaner
body (B) until it clicks into place.
1. Cleaner asseMBlY (Cont’d)
power Cord asseMBlY
1.6 1.7
1.11
A
B
1.8 1.9
1.10 A
B
A
A
1.12