Hoover Jazz TJA1440 User manual

1
®
®
PRINTED IN P.R.C. U* V* X*W*
*Certain models only ** May vary depending on model
A
B
C
D
E
F
H
G
H
J
I
K
L
M
N*
O
T
P
Q**
R**
S
T
Y*
INSTRUCTION MANUAL
ENGLISH GB
Tb
Tc
Ta
C
M
Y
CM
MY
CY
CMY
K
Rush Extra israel ML cover.pdf 1 7/26/2011 10:41:59 AM
48005609

2 3 54
10 11 1312
6 7 98
**
*
** 14 15 1716
18 21
22 23
20
19
*Certain Models Only **May vary depending on model
24 25
*

1
IMPORTANT SAFETY REMINDERS
This cleaner should only be used for domestic cleaning, as described in this user guide.
Please ensure that this guide is fully understood before operating the appliance. Use only
attachments recommended or supplied by Hoover.
WARNING: Electricity can be extremely dangerous. This appliance is double insulated
and must not be earthed. This plug is tted with a 13 amp fuse (UK only).
IMPORTANT: The wires in the mains power lead are coloured in accordance with the
following code: Blue – Neutral Brown – Live
STATIC ELECTRICITY: Some carpets can cause a small build up of static electricity.
Any static discharge is not hazardous to health.
AFTER USE: Switch the cleaner off and remove the plug from the electricity supply.
Always switch off and remove the plug before cleaning the appliance or attempting any
maintenance task.
SAFETY WITH CHILDREN, ELDERLY OR THE INFIRM: This appliance is not intended
for use by persons (including children) with reduced physical, sensory or mental capabili-
ties, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
HOOVER SERVICE: To ensure the continued safe and efcient operation of this appli-
ance we recommend that any servicing or repairs are only carried out by an authorised
Hoover service engineer.
IT IS IMPORTANT THAT YOU DO NOT:
• Position the cleaner above you when cleaning the stairs.
• Use your cleaner out of doors or on any wet surface or for wet pick up.
• Pick up hard or sharp objects, matches, hot ashes, cigarette ends or other
similar items.
• Spray with or pick up flammable liquids, cleaning fluids, aerosols or their vapours
as this may cause risk of fire / explosion.
• Run over the power cord when using your cleaner or remove the plug by pulling
on the power cord.
• Stand on or wrap the power cord around arms or legs when using the cleaner.
• Use the appliance to clean people or animals.
• Continue to use your cleaner if it appears to be faulty. If the power cord is damaged
stop using the cleaner IMMEDIATELY. To avoid a safety hazard, an authorised
Hoover service engineer must replace the power cord.
GETTING TO KNOW YOUR CLEANER
A. Cleaner main body
B. Dust Container
C. Dust Container handle
D. Dust Bin
E. On/Off Button
F. Cord Rewind Button
G. Dust Container Release Button
H. Dust Container Door Release Trigger
I. Multi-cyclonic Separation Unit
J. Multi-cyclonic Separation Unit Handle
K. Pre motor Filter Pack
L. Parking slot
M. Handle
N. Suction Regulator*
O. Telescopic Tube
P. Telescopic tube adjuster
Q. Carpet & Floor Nozzle**
R. Carpet Care Control Selector**
S. Hose
T. 3 in 1 tool
Ta. Dusting Brush
Tb. Crevice Tool
Tc. Furniture nozzle
U. Parquet Caresse Nozzle*
V. Pet Hair Remover Mini Turbo Nozzle*
W. Allergen Remover Mini Turbo Nozzle*
X. Grand Turbo Nozzle*
Y. Stair Cleaning stretch Hose*
ASSEMBLING YOUR CLEANER
Remove all components from the packaging.
1. Connect the hose to the cleaner main body, ensuring it clips and locks into position.
To release: simply press the two buttons on the hose end and pull. [2]
2. Connect the tube upper end to the hose handle and store the accessories on the
handle. [3]
3. Connect the tube lower end to the carpet and oor nozzle. [4]
* Certain models only
** May vary depending on model
JAZZ TEXT.indd 1 4/27/2012 10:39:00 AM

2
USING YOUR CLEANER
1. Extract power cord and plug it into the power supply. Do not pull the cord beyond
the red marker. [6]
2. Adjust the telescopic tube to the desired height by moving the telescopic release
button up and raise or lower the handle to the most comfortable cleaning position.
[7]
3. Carpet and Floor Nozzle** - Select carpet care control** height by pressing the
pedal in the nozzle. [8]
Hard Floor – Brushes are lowered to protect the oor.
Carpet – Brushes are raised for the deepest clean.
4. Switch the cleaner on by pressing the On/Off Button on the cleaner main body. [9]
5. Adjust the suction by moving the suction regulator to the desired level.* [10]
6. Switch off at the end of use by pressing the On/Off Button. Unplug and press the
cord rewind button to wind the power cord back into the cleaner. [11]
7. To store your cleaner adjust telescopic tube to the lowest height setting and park the
nozzle in the parking slot on the cleaner main body. [12]
ACCESSORIES AND NOZZLES
All accessories can be tted to the end of the hose handle or to the end of the telescopic tube.
3 in 1 tool – Combines several functions in one. The 3 in 1 tool can be stored neatly
underneath the hose handle. [1]
Dusting Brush – For bookshelves, frames, keyboards and other delicate areas. To ex-
tend the brushes push the button on the body of the tool. [22]
Crevice Tool – For corners and hard to reach areas. [23]
Furniture Nozzle – For soft furniture and fabrics [24]
Parquet Caresse Nozzle* – For parquet oors and other delicate oors. [1U]
Pet Hair Remover Mini Turbo Nozzle* - Use the mini turbo nozzle on stairs or for deep-
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for pet
hairs removal. [1V]
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for
deepcleaning on textile surfaces and other hard to clean areas. Particularly suitable for
allergen removal. [1W]
Grand Turbo Nozzle* – Use the turbo nozzle for deep cleaning on carpets. [1X]
Stair Cleaning Stretch Hose* – Use for stair cleaning and areas requiring long reach.
[1Y] Use this in addition to the standard cleaner hose. Attach the hose to the end of the
hose handle. [25]
IMPORTANT: Do not use the grand turbo and mini turbo nozzles on rugs with long
fringes, animal hides and carpet pile deeper than 15mm. Do not keep the nozzle station-
ary while the brush is rotating.
CLEANER MAINTENANCE
Emptying the Dust Container
When the dust reaches the max level indicator in the container empty the dust bin.
IMPORTANT:To maintain optimum performance do not allow the dust to sit higher than
the max level.
1. Release the container by sliding the dust container release button towards the rear
of the cleaner. [13] Lift the dust container from the cleaner main body.
2. Hold the dust container over a bin with one hand and press the bin container door
open trigger. [14]
3. Close the dust container door and ret to the cleaner main body.
Cleaning the washable lters
The cleaner is tted with a blue lter pack. To maintain optimum cleaning performance
regularly remove the the lters and tap against the side of the bin to release dust. The
lters should be washed every 3 months or when the lter has excessive dust level.
IMPORTANT: All bagless cleaners require regular lter cleaning. Failure to clean
your lters may result in air blockage, overheating and product failure. This may
invalidate your guarantee.
IMPORTANT: Always ensure the lters are fully dry before use.
To access the pre-motor lter:
1. Release the container by sliding the dust container release button towards the rear
of the cleaner. [13] Lift the dust container from the cleaner main body.
2. Hold the dust container with one hand and with the other hand rotate the bin handle
anti clockwise to release it from the dust container. [15]
3. Remove the blue lter pack located in the dust container handle. [16]
4. Remove the foam lter from the lter pack. [17]
5. Gently tap and wash the lter using warm water. Do not use hot water or detergents.
Remove excess water from the lter and leave to dry fully before re-using. [18]
6. Reassemble to lter pack once fully dry and ret to the cleaner.
IMPORTANT: Do not use the product without the lter pack tted.
To access the exhaust lter:
1. Unclip the exhaust lter from the rear of the cleaner. [19]
2. Gently tap and wash the lter using warm water. Do not use hot water or detergents.
Remove excess water from the lter and leave to dry fully before re-using.
* Certain models only
** May vary depending on model
JAZZ TEXT.indd 2 4/27/2012 10:39:00 AM

3
Cleaning the dust container / multi-cyclonic separation unit
This cleaner uses a multicyclonic separation system, unique to Hoover. If necessary the
separation unit can be disassembled from the dust container and cleaned.
1. Release the dust container by sliding the dust container release button towards the
rear of the cleaner. [13] Lift the dust container from the cleaner main body.
2. Hold the dust container with one hand and with the other hand rotate the dust con-
tainer handle anti clockwise to release it from the dust container. [15]
3. Remove the multicyclonic separation unit from the dust container by pulling the
handle provided.[20]
4. If necessary, use a cloth to remove excessive dust from the multi-cyclonic unit sur-
face. [21]
5. Reassemble the multicyclonic separation unit to the dust container and ret the lter
pack in position.
6. Reassemble the dust container handle to the bin container. Ret the dust container
to the cleaner.
Note: For stubborn dirt the multi-cyclonic separation unit, or the dust container can be
washed, but care must be taken to ensure that both are completely dry before use.
Important: For optimum performance, we recommend that the multi-cyclonic separation
system is inspected after each empty.
Removing a blockage from the cleaner
1. Check if the dust container is full. If so refer to ‘Emptying the dust container.
2. If the dust container is empty but suction is still low:
A. Do the lters need cleaning? If so refer to ‘Cleaning the washable lters’.
B. Check if there is any other blockage in the system - Use a rod or pole to remove
any blockage from the extension tube or exible hose.
C. Check if pre-motor lter is tted.
D. Check if the separation unit needs to be cleaned. Refer to ‘Cleaning the separa-
tion unit’
USER CHECKLIST
Should you have a problem with the product, complete this simple user checklist
before calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another
electrical appliance.
• Is the dust container over-filled? Please refer to ‘Cleaner Maintenance’.
• Is the filter blocked? Please refer to ‘Cleaner Maintenance’.
• Is the hose or nozzle blocked? Please refer to ‘Removing a blockage from the
system’.
• Has the cleaner overheated? If so, it will take approximately 30 minutes to automati-
cally reset
IMPORTANT INFORMATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model num-
ber.
Consumables
• Hepa / Foam Filter pack: U64 35601223
Spares
• Carpet and Floor Nozzle: G140 35601226
• Flexible Hose: D132 35601224
• Stretch Hose: D133 35601225
• Grand Turbo Nozzle: J55 35601206
• Mini Turbo Nozzle: J56 35601227
• Parquet Caresse Nozzle: G133PC 35601205
Hoover Service
Should any faults occur with your cleaner during the rst 12 months contact the Hoover
Customer Helpline on the number below.
Tel: [phone]
Email: [email protected]
Hoover have a computerised nationwide service network of over 500 engineers who will
quickly respond to your call and guarantee your repair for 12 months.
* Certain models only
JAZZ TEXT.indd 3 4/27/2012 10:39:00 AM

4
Quality
Hoover’s factories have been independently assessed for quality. Our products are
made using a quality system which meets the requirements of ISO 9001
The Environment:
This appliance is marked according to the European Directive 2002/96/EC on Waste
Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of
correctly you will help prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate waste handling of this
product.
The symbol on the product indicates that this product may not be treated as
houshold waste. Instead it shall be handed over to the appliance collection
point for recycling of electrical and electronic equipment. Disposal must be
carried out in accordance with the local environmental regulations for waste
disposal. For more detailed information about treatment, recovery and re-
cycling of this product, please contact your local city ofce, your household
waste disposal service or the shop where you purchased the product.
Your Guarantee
The guarantee conditions for this appliance are as dened by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be pro-
duced when making any claim under the terms of this guarantee.
Subject to change without notice.
JAZZ TEXT.indd 4 4/27/2012 10:39:00 AM