*Certain Models Only ** Certain models only, nozzles may vary according to model
USER CHECK LIST
Should you have a problem with the product, complete this simple user checklist before
calling your local HOOVER service.
Is there a working electricity supply to the cleaner? Please check with another
electrical appliance.
Is the dust bag over-filled? Please refer to ‘Cleaner Maintenance’.
Is the filter blocked? Please refer to ‘Cleaner Maintenance’.
Is the hose or nozzle blocked? Please refer to ‘Removing a blockage from the system’.
Has the cleaner overheated? If so, it will take approximately 45 minutes for the cut
out to automatically reset.
IMPORTANT INFORMATION
HOOVER spares and Consumables
Always replace parts with genuine HOOVER spares. These are available from your local
3
2. [18]
[19]. Remove excess
[20]
REMEMBER: Do not use hot water or detergents. In the unlikely event of the
Cleaning the Permanent Dust Bag* (certain models only)
To maintain optimum performance we recommend that you wash the permanent dust bag
warm water, remove excess water with a dry cloth and leave to dry fully before replacing.
Removing a blockage from the system
If the bag check indicator is red:
2. If it is not full, then;
A.
If so, refer to ‘Cleaning the Filter’.
C. Check for and clear any blockage in the Nozzle.
WARNING: - The bag check indicator will turn red if the cleaner is used when full, if there is a
bag check indicator red, a thermal cut out will switch the cleaner off to prevent overheating. The
bag check indicator turn green once the cleaner has switched off to signal that the thermal cut
out has been activated. If this should happen, switch the cleaner off, unplug and correct the
fault. It will take about 45 minutes for the cut out to automatically reset.
ACCESSORIES AND NOZZLES
#1 it is recommended that the
correct nozzles are used for the main cleaning operations. These nozzles are indicated
in the diagrams by the letters GP, HF or CA.
A nozzle type GP
A nozzle type HF
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended
for occasional use only.
by European Regulation (EU) 665/2013.
If the label shows a red prohibition circle on the left covering the carpet symbol, then this
indicates that the vacuum cleaner is not suitable use on carpets.
#1 NOTE: -
cord with Commission Regulations (EU) 665/2013 and (EU) 666/2013.
Please see the model specication on the packaging label for inclusion of accessories to
individual models.
All accessories can be tted to the hose handle or the end of the telescopic tube.
•2 in 1 accessory – For corners and hard to reach areas and bookshelves, frames, keyboards
and other delicate areas [Q]. Remove the 2in1 accessory from the rear of the cleaner [11]
onto the end of the handle. [12]
Parquet Nozzle**–
[Z1, Z2]
Pet Hair Remover Mini Turbo Nozzle* -
Use the mini turbo nozzle on stairs or for deep cleaning
on textile surfaces and other hard to clean areas. Particularly suitable for pet hairs removal. [W]
Allergen Remover Mini Turbo Nozzle* –
Use the mini turbo nozzle on stairs or for deep cleaning
on textile surfaces and other hard to clean areas. Particularly suitable for allergen removal. [X]
Grand Turbo Nozzle
[Y]
IMPORTANT:
animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush
is rotating.
