
3
A nozzle type HF is suitable for use only on hard oor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended
for occasional use only.
It is important to note that this vacuum cleaner is supplied with an Energy Label as
required by European Regulation (EU) 665/2013.
If the label shows a red prohibition circle on the left covering the carpet symbol, then this
indicates that the vacuum cleaner is not suitable use on carpets.
If the label shows a red prohibition circle on the right covering the hard oor symbol, then
this indicates that the vacuum cleaner is not suitable for use on hard oors.
#1 NOTE: Dust pick up ability carpet, dust pick up ability hard oor, and energy efciency
in accord with Commission Regulations (EU) 665/2013 and (EU) 666/2013.
The Crevice tool, Furniture nozzle and Dusting brush are stored on board under
the accessories door.
All accessories can be tted to the end of the handle or the end of the telescopic
tube.
Accessory Set :
Crevice Tool –
For corners and hard to reach areas.
[w1]
Furniture Nozzle – For soft furniture and fabrics. [w2]
DustingBrush–For bookshelves, frames, keyboards and other delicate areas. [W3]
Parquet Nozzle* – For parquet oors and other delicate oors. [Z]
Pet Hair Remover Mini Turbo Nozzle* - Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for pet
hairs removal. [X]
AllergenRemoverMiniTurboNozzle*–Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas, particularly suitable for allergen
removal. [Y]
IMPORTANT: Do not use mini turbo nozzles on rugs with long fringes, animal hides and
carpet pile deeper than 15mm. Do not keep the nozzle stationary while brush is rotating.
CLEANER MAINTENANCE
For models equipped with LED bag check indicator* (see H1), both full bag and
obstructions are signaled by a red light on the display.
For models equipped with the other type of bag check indicator* (see D), the mechanism
turns red if bag is full and if obstructions occur.
ReplacingtheDustBag
If the bag check indicator turns red on the bag door* (see D), or on the display*(see H1)
please check the bag and, if necessary, replace with it.
1. Lift the bag door release latch, open the bag door and remove the bag.
[12,13]
The
full dust bag should be disposed correctly and carefully.
[14]
2. Fold a new bag as shown on the bag and t by inserting the collar into the bag
holder.
[13]
3. Close the Bag door.
WARNING: The bag door will NOT close if the dust bag and/or the bag holder
are not assembled to the cleaner. Always ensure the bag is present when closing
the bag door.
REMEMBER: The bag check indicator also turns red (D or H1)** if an obstruction
has occurred. In this case refer to ‘Remove a Blockage from the System’.
CleaningtheFilters
To ensure constant optimum performances from your cleaner, please wash the
lters after each 5 bag changes.
Cleaningthepre-motorlter:
1. Lift the bag door release latch to open bag door and remove the bag. [12,13]
2. Remove the pre-motor lter frame from the cleaner. [15]
3. Remove the lter from the pre-motor lter frame. [16]
4. Wash the pre-motor lter and the pre-motor lter frame using hand warm water, and
allow it to dry thoroughly before inserting into the cleanerr. [19,20]
Cleaningtheexhaustlter
1. Remove the exhaust lter, unclip the exhaust lter cover and remove the exhaust
lter pack.
[17,18]
2. Wash the exhaust lter pack in hand warm water, and allow it to dry thoroughly
before inserting into the cleaner.
[19,20]
Remember: Do not use hot water or detergents. In the unlikely event of the lters
becoming damaged, t a Genuine Hoover replacement. Do not try and use the product
without a dust bag or lters tted.
Cleaningthepermanentclothdustbag*(*Certainmodelonly)
To maintain optimum performance we recommended that you wash the permanent cloth
dust bag after every 5 full bags. Empty the contents of the bag into a bin, wash the bag
under warm water, remove excess water and leave to dry fully before replacing.
Removingablockagefromthesystem
If the bag check indicator turns red* (D) or remains lit* (H1):
1. Check if the bag is full. If so refer to ‘Replacing the Dust Bag’.
2. If it is not full, then:
A. Do the lters need cleaning? If so refer to ‘Cleaning the Filter’.
B. Check if there is any other blockage in the system.
*Certain Models Only ** May vary according to model
GB