Hoover T 185 E/1 User manual

EN The manufacturer declines all responsability in the event of any
printing mistakes in this booklet. The manufacturer also reser-
ves the right to make appropriate modifications to its products
without changing the essential characteristics.
RU
T 185 E/1
T 205 E/1
T 225 E/1
T 120 E
04-02
46 000 259
User instructions
EN
RU

EN RU
EN RU
2 3
1
90
2
60
3
40
4
5
90
6
60
7
40
8
9
10
40
11
12
Please read this booklet
carefully as it provides
important guidelines for safe
installation, use and
maintenance and some useful
advise for best results when
using your washing machine.
Keep this booklet in a safe
place for further consultation.
When contacting HOOVER or
a Customer Services Centre
always refer to the Model, No.,
and G number (if applicable) of
the appliance (see panel).
..................... 3 .......................
..................... 4 .......................
..................... 5 .......................
..................... 6 .......................
..................... 8 .......................
..................... 9 .......................
.................... 12 ......................
.................... 16 ......................
.................... 18 ......................
.................... 19 ......................
.................... 21 ......................
.................... 22 ......................
.................... 26 ......................
.................... 29 ......................
.................... 30 ......................
.................... 31 ......................
INDEX
Introduction
General points on delivery
Guarantee
Safety Measures
Technical Data
Setting up and Installation
Control Description
Opening the lid
Detergent dispenser
Selection
The Product
Ta b le of Programmes
Washing
Cleaning and routine
maintenance
Cleaning the filter
Faults Search

EN RU
EN RU
GENERAL
POINT ON
DELIVERY
On delivery, check that the
following are included with the
machine:
A)INSTRUCTION MANUAL
B) CUSTOMER SERVICE
ADDRESES
C) CAPS
KEEP THEM IN A
SAFE PLACE
also check that the machine
has not incurred damage during
transport. If this is the case,
contact your nearest HOOVER
Centre.
SAFETY AQUASTOP
(Mod. T 185 E/1 - T 205 E/1 -
T 225 /1)
This appliance is fitted with a
safety system (aquastop), which
ensures maximum freedom from
anxiety for users. A water leak
detector sensor located along the
inlet pipe and the devoce fitted
to the tap, automatically block the
flow of water in the case of acci-
dental leaks. Even without
electricity supply.
4 5
D
B
A
GUARANTEE
The appliance is supplied with a
guarantee certificate which allows
free use of the Technical
Assistance Service for a period of
one year from the date of
purchase.
Remember to post part Bof the
guarantee certificate within 10
days of the purchase date.
Part Ashould be filled in and kept
by you to be shown if necessary
to the technician from the
Technical Assistance Service. The
sales receipt should also be kept.

EN RU
EN RU
6 7
SAFETY
MEASURES
IMPORTANT:
FOR ALL CLEANING
AND MAINTENANCE
WORK
•Remove the plug
•Turn off the water inlet tap.
•HOOVER fits all its machines
with an earth conncetion.
Ensure that the electrical
installation has an earth
connection and that it is
connected; if not call for service.
The earth connection is
essential for user safety, as it
eliminates the risk of electrical
discharge.
The manufacturer cannot
accept any responsibility
for any damage or injury
due to connection
problems or faults, a
defective earth connection
or for not having
connected it.
•Do not touch the appliance
with wet or damp hands or feet.
•Do not use the appliance when
bare-footed.
•Extreme care should be taken
if extension leads are used in
bathrooms or shower rooms.
Avoid this where possible.
WARNING: DURING THE
WASHING CYCLE, THE
WATER CAN REACH A
TEMPERATURE OF 90 ° C.
•Do not use adaptors or
multiple plugs.
•Do not allow the appliance to
be used by children without due
supervision.
•Do not pull the mains lead or
the appliance itself to remove
the plug from the socket.
•Do not leave the appliance
exposed to atmospheric agents
(rain, sun etc.)
Important!
Do not install the washing
machine on a surface which
blocks the space be ween the
floor and the base of the
appliance, like for example,
carpets, rugs, etc., as this could
cause overheating due to lack
of ventilation.
•Lift the appliance in pairs as
illustrated in the diagram.
•In the case of failure
and/or bad functioning, turn the
washing machine off, close the
water inlet tap and do not
tamper with the appliance.
Contact a HOOVER Technical
Assistance Centre for any
eventual repairs and ask for
original HOOVER spare parts.
Avoidance of these points may
compromise the safety of the
appliance.

EN RU
EN RU
A
B
AA
B
A
A
D
AD
A
A
DRY LOAD CAPACITY
NORMAL WATER LEVEL
WASH MOTOR POWER
SPIN MOTOR POWER
ELECTROPUMP POWER
POWER RESISTANCE
MAX ABSORBED POWER
ENERGY CONSUMPTION
(PROG.60º C)
POWER CURRENT FUSE
AMPERE
SPIN
r.p.m.
WATER SUPPLY PRESSURE
kg
I
W
W
W
W
W
kWh
A
giri/
min.
Mpa
8 9
T 185 E/1 T 205 E/1 T 225 E/1
4,5
59
125
340
30
1950
2200
0,85
10
1200
0,05 min.
0,8 max.
T 185 E/1
T 205 E/1
T 225 E/1
T 120 E
T 120 E
4,5
59
175
300
30
1950
2200
0,85
10
850
0,05 min.
0,8 max.
4,5
59
125
340
30
1950
2200
0,85
10
1200
0,05 min.
0,8 max.
TECHNICAL DATA SETTING UP
INSTALLATION
Remove the 4 screws (A) from
the clamp and the other 4
screws (B).
Replace the 4 screws (A) and fit
the trims provided (D).
WARNING:
DO NOT LEAVE THE
PACKAGING IN THE
REACH OF CHILDREN AS
IT IS A POTENTIAL
SOURCE OF DANGER.
4,5
59
175
400
30
1950
2200
0,85
10
1000
0,05 min.
0,8 max.

EN RU
EN RU
10 11
Connect one end of the water
inlet pipe to the electrovalve
(top back part of the machine)
and the other to a tap or a
permanently plumbed-in
3/4” threaded connection.
IMPORTANT:
DO NOT TURN THE TAP
ON.
(Mod. T 185 E/1 - T 205 E/1 -
T 225 /1)
To move the washing machine
easily, turn the lever to the right.
Once you have finished moving
the machine, return the lever to
its original position.
Position the washing machine
next to the wall. Hook the outlet
pipe to the edge of the bath tub,
paying attention that there are
no bends along the tube.
It is better to connect the outlet
tube to a fixed outlet of a
diameter greater than that of
the outlet pipe and at a height
of min. 50 cm. If necessary use
the rigid bend supplied.
A
B
C
•
•
•
•
•
Use the front feet to level
the machine
a) Tu rn the nut clockwise to
release the screw adjuster for
the foot.
b) Rotate the foot to raise or
lower it until it stands firmly on
the ground.
c) Lock the foot in position by
turning the nut anticlockwise
until it comes up against the
bottom of the machine.
Check that the appliance is
properly levelled. To do so, try
and move the washing
machine by pushing on two
diagonally opposite top
corners at the same time to
see if it rocks.
If you move your washing
machine from oplace to
another, level the feet again.
Important!
If your washing machine is not
properly levelled, it will not
work properly. There could be
a lot of noise and unusual
vibrations.
Ensure that the machine is
switched off.
Ensure that all controls are set
to “0” and that the lid is shut.
When you close the door you
will hear a “click” confirming
that it is properly closed.
Insert the plug.
Press the On/Off button. The
power on light will light up. If
this does not light up see the
faults search section of this
booklet.

EN RU
EN RU
.................... A.................
.................... B .................
.................... C ................
.................... D .................
.....................E .................
..................... F .................
.................... G ................
.................... H .................
..................... L .................
.................... M ................
.................... N.................
.................... O ................
.................... P .................
12 13
CONTROLS
Timer knob for wash
programmes
Washing cycle temperature
control knob
Spin speed control
Anticreasing button
Extra-rinse button
Extra-delicate button
ON/OFF Indicator light
ON/OFF Button
Lid
Syphons
Drum opening button
Drum
Detergent gate
T 185 E/1
T 205 E/1
T 225 E/1
T 120 E
CONTROL
DESCRIPTION
A
B
OK
OK
•
•
•
•
•
•
•
•
•
PROGRAM
C
TIMER CONTROL FOR WASH
PROGRAMMES
IMPORTANT:
ALWAYS ROTATE THE
CONTROL IN A
CLOCKWISE DIRECTION,
NEVER IN AN ANTI-
CLOCKWISE DIRECTION.
DO NOT PRESSTHE “ON”
BUTTON (H) BEFORE
SELECTING THE
PROGRAMME
The tables describe the
washing programme on the
basis of the number or symbol
chosen.
WASHING CYCLE
TEMPERATURE CONTROL
KNOB
ROTATES IN BOTH
DIRECTIONS
This washing machine is fitted
with this device to select the
wash temperature required.
WARNING :
THE TEMPERATURE
SELECTED WITH THE
SELECTOR MUST NEVER
BE HIGHER THAN THAT
INDICATED IN THE WASH
PROGRAMME TABLE.

EN RU
EN RU
EXTRA RINSE BUTTON
By pressing the “EXTRA
RINSE” button, even the
slightest residue of detergent is
removed from fabrics. This is
particularly important for people
with delicate skins.
EXTRA-DELICATE BUTTON
Press this button to reduce the
number of drum revolutions
from 55 to 40 revolutions per
minute.
This gives an extra-delicate
wash, which is especially
recommended for wool and
very delicate fabrics. It is also
recommended for mixed
fabrics, articles which are not
very dirty and for fabrics which
do not need to be ironed.
ON/OFF INDICATOR LIGHT
ON/OFF BUTTON
SPIN SPEED CONTROL
ROTATES IN BOTH
DIRECTIONS
The spin cycle is very important
to remove as much water as
possible from the laundry
without damaging the fabrics.
You can adjust the spin speed
of the machine to suit your
needs.
The final spin for strong fabrics
at 400 rpm lasts 1´; at 850 rpm.
(Mod. T 185 E/1), 1000 rpm.
(Mod. T 205 E/1), 1200 rpm.
(Mod. T 225 E/1 - T 120 E) lasts
3´.
By adjusting the control, it is
possible to reduce the
maximum speed, completely
eliminating the spin
(position ) if required.
FLOT BUTTON
This function is recommended
for synthetics or delicates. If this
button is not pressed your
machine will drain normally.
When the button is pressed the
machine will stop full of water at
the end of last rinse. (Program
6-7-8-10-11). To finish the
programme with the spin cycle,
press the button again to
release it.
14 15
C
D
OK
•
•
•
E
F
G
H

EN RU
EN RU
16 17
A
FRONT OF THE
WASHING
MACHINE
D
C
FRONT OF THE
WASHING
MACHINE
D
C
FRONT OF THE
WASHING
MACHINE
C
B
D
WASHING
MACHINE LID
Ensure that both shutters are
perfectly aligned and properly
closed.
IMPORTANT: IT IS
IMPORTANT TO MAKE
SURE THAT THE DRUM IS
CAREFULLY CLOSED
BEFORE OPERATING THE
MACHINE, OTHERWISE
THE MACHINE OR
LAUNDRY COULD GET
DAMAGED.
IMPORTANT: A SPECIAL
SAFETY DEVICE
PREVENTSTHE LID FROM
BEING OPENED
IMMEDIATELY AFTER THE
WASH HAS FINISHED.
ONCE THE SPIN CYCLE
HAS FINISHED, WAIT FOR
2 MINUTES BEFORE
TRYING TO OPENTHE LID.
OPENING THE
DRUM
Lift the lid (A) and open
completely. Next open the drum
door following these instructions:
Press catch (B) and kept it
pressed down.
Press the first shutter (C) to
unlock the two shutters (C) and
(D).
Open the second shutter (D).
Open the first shutter (C).
Place the washing in the drum.
Close the first shutter (C).
Close the second shutter (D)
so that the catch on the first
shutter fits correctly into the
slot. Release.
2 min.
FRONT OF THE
WASHING
MACHINE
C
D

EN RU
EN RU
DETERGENT
DISPENSER
The detergent dispenser is
divided into 4 compartments:
-COMPARTMENT I is for
prewash detergent, either
liquid or powder.
-COMPARTMENT II is for wash
detergent.
1For POWDERED
DETERGENT, the blue gate
should be in the top
position. To do this, pull the
gate up.
2For LIQUID DETERGENT,
the blue gate should be in the
bottom position. To do this,
push the gate right down.
* Before doing this, check
that there is no water
remaining from the previous
wash. If there is, drain the
water by lifting the gate.
CAUTION:
REMEMBER THAT SOME
DETERGENTS DO NOT
GET TAKEN AWAY EASILY
BY THE WATER. IN THIS
CASE, IT IS BEST TO PUT
A "WASH BALL"
STRAIGHT IN THE DRUM.
-The compartment is for
bleach.
-The compartment is for
special additives, fabric
conditioners, scenting agents,
starch, bluing agents, etc.
18 19
1
2
SELECTION
For the various types of fabrics
and various degrees of dirt the
washing machine has 3
different programme bands
according to: wash cycle,
temperature and length of cycle
(see table of washing cycle
programmes).
1 Strong Fabrics
The programmes have been
designed for a maximum wash
and rinses, with spin intervals,
ensure perfect rinsing. The
gradual reduction of the water
temperature ensures less
creasing of fabrics.
2 Mixed and Synthetic
Fabrics
Pre-wash and main wash give
best results thanks to the
rotation rhythms of the drum;
the rinses with high water levels
ensure delicate treatment and
best results.