Sprue R (x2)
Sprue L (x2)
Applying Decals
WARNING
© Horizon Models Pty Ltd 2018. All rights reserved.
1
2
3
4
5
6
7
Cut the decal from the carrier sheet.
Dip the decal into water for about 10 seconds.
Place the decal on a cloth to absorb excess moisture.
Wet the model where you want to place the decal.
Slide the decal from the backing paper directly onto the model.
Do not lift the decal off the sheet as this may cause it to fold.
Once positioned correctly, press the decal gently with a soft cloth.
CHOKING HAZARD: KEEP AWAY FROM CHILDREN UNDER THREE YEARS OF AGE.
DO NOT USE PAINTS OR GLUES NEAR FLAMES OR FIRE, OR WITHOUT ADEQUATE VENTILATION.
This model is intended for ages 14 and older.
Beware of small and/or sharp parts.
Throw away plastic bags when no longer required.
Horizon Models Pty Ltd
PO Box 305
Drummoyne NSW 2047
Australia
www.horizon-models.com
Assembly
1
2
3
4
5
6
7
8
9
Study these instructions carefully before assembly and note the payload and marking options that you will build.
Remove the parts from the sprue one at a time with a sprue cutter, and carefully sand off any excess plastic.
Test fit the parts to ensure they fit correctly, then glue into place using polystyrene glue.
Some parts should be painted prior to gluing to the main assembly.
Before painting, carefully sand the model if required, then wash it in a soapy solution.
Allow to dry thoroughly before applying paint.
Paint the model in a well ventilated area, and allow to dry thoroughly.
Apply the decals (see instructions below).
Seal the decals with a clear coat of paint (allow at least one day for the decals to dry thoroughly).
PAINT AND GLUE NOT INCLUDED
Use paints and glues in a well ventilated area.
Take care when handling knifes and other sharp objects.
MADE IN AUSTRALIA
!
1
2
3
4
5
6
7
8
9
IRBM Fuselage
Juno I Upper Stages
Sparta/WRESAT Upper Stage A
Sparta/WRESAT Upper Stage B
Juno I Upper Stages
IRBM Fin
Juno I Fuselage
Explorer I Satellite
Sparta/WRESAT Stage
1
2
3
4
5
6
7
8
9
10
11
12
13
Fuselage Half
Upper Fuselage
Fin Half A
Fin Half B
Base with Nozzle
Exhaust Flame Deflector
Launch Adaptor Ring
Spacecraft Adaptor
Launch Stand Brace (x2)
Movable Rudders (x2)
Valve
Couplings Shroud
Carbon Jet Vane (x2)
PER1
PER2
PER3
PER4
PER5
Launch Ring Detail (x8)
Antenna (x4)
Explorer I Whip Antenna (x2)
Not used (x3)
Alcohol Fill and Drain Port
Juno I
Photo Etched Parts - Redstone (PER)
Use a cyanoacrylate glue to attach Photo-Etched parts
R12
3
4
5
8
7
6
9
11
9
10
13
13
10
12
PE 0002 1/72 REDSTONE V2
©HORIZON MODELS PTY LTD 2016
1111
111 1
2 2
22
3344
4
5
PE 0002 1/72 REDSTONE V2
©HORIZON MODELS PTY LTD 2016
1111
111 1
2 2
2 2
3344
4
5
