Kit Contents
1 x Motion Sensor Solar Wall Light
Lighting Modes
1Medium light mode (flashes once)
Light automatically comes on at dusk and off at dawn.
Motion sensor will not be active on this setting.
2Dim light sensor mode (flashes twice)
Continuously emits a dim light (18 LEDs) from dusk until dawn,
with a bright light for 15-20 seconds when motion is detected.
3Bright Sensor mode (flashes three times)
Light remains on standby mode until motion is detected
then a bright light will emit for 15-20 seconds.
Activate the Light
To activate the light, click the IO button on the side of
the light. The button with the M printed on it will allow
you to change between lighting modes.
Test by covering the solar panel completely to check
that the light comes on. The light is now ready for use.
Product Installation
STEP 1 Find a suitable location
Solar lights need access to direct sunlight for optimum
results; preferably 6-8 hours per day. The motion sensor
will detect movement up to 5m away.
STEP 2 Install the light
Installation - Option 1
Using adhesive outdoor tape.
Adhere using Hoselink Outdoor Acrylic Double-Sided
Tape (SKU L100), sold seperately. Be sure to stick the tape
onto the stainless-steel plate on the back of the light.
Installation - Option 2
Using supplied hardware.
Use a 6mm drill piece for masonry installation. Once your
hole is drilled, gently hammer the plugs into place and
then secure the screws tightly. For timber, use a 3mm drill
piece without the plugs. Hang the light and enjoy.
Be sure to clean the solar panel periodically to maintain
optimal performance.
Specifications
NOTE: if the light does not turn on, this could be
due to the battery not being charged. Leave out in
direct sunlight for 6–8 hours and try again.
Solar panel 5V / 1.7W
LED Lumens 300 lumens ( bright light)
Light Temperature 6500 kelvins
Lithium Battery 2000mAh / 3.7V
Charge Time 8 hours
Working Time Up to 90 hrs depending
on light mode
