
Kit Contents
1 x Spotlight
3 x Screws
3 x Plugs
Lighting Mode
Dim light sensor mode
Continuously emits a dim light (6 LEDs) from dusk until dawn,
with a bright light for 15-20 seconds when motion is detected.
Activate the Light
To activate the light, click the IO button on the back of
the light. Test by covering the solar panel completely to
check that light comes on. The light is now ready for use.
Product Installation
STEP 1 Find a suitable location
Solar lights need access to direct sunlight for optimum
results; preferably 6-8 hours per day. The motion sensor
will detect movement up to 5m away.
STEP 2 Mounting the light
Use a 6mm drill piece for masonry installation. Once your
hole is drilled, gently hammer the plugs into place and
then secure the screws tightly. For timber, use a 3mm drill
piece without the plugs. Hang the light and enjoy.
Be sure to clean the solar panel periodically to maintain
optimal performance.
Specifications
NOTE: if the light does not turn on, this could be
due to the battery not being charged. Leave out in
direct sunlight for 6–8 hours and try again.
Solar panel 5.5V / 1.22W
LED Lumens 2.5 lumens ( dim light)
200 lumens ( bright light)
Light Temperature 6500–6500 kelvins
Lithium Battery 2000mAh / 3.7V
Charge Time 6–8 hours
Waterproof Rating IP65