7
DISHWASHER
First of all.
- Turn on the water supply
tap completely.
- Add the correct amount
of detergent.
- Load the baskets cor-
rectly.
- Check that the spray
arms rotate freely.
- Close the door securely.
-
Press the ON-OFF button "A":
indicatorlight"B"comeson. The
displayturnsonand3dashesap-
pear,theseindicatethatthedish-
washer is now awaiting instruc-
tions.
Select the wash cycle.
turnknob "M"untiltheindicatoris
inlinewiththenumberorsymbol
for the cycle required.Select the
wash cycle most suitable for the
typeofdishesto wash(see‘Pro-
gramme Chart’).
Afterafewseconds,youwillhear
ashortbeep: thewashcyclehas
startedandindicator"G"displays
thecyclephase startingsymbol.
The counter "L" will show the
amountoftimeleftuntiltheendof
thewashcycle.
Indicator lights.
Yourdishwasherisprovidedwith
anindicatorlight "G"with4sym-
bolswhichcome onastheappli-
ancecarriesouteachphaseofthe
selectedprogramme.
These indicator lights represent
eachphasecorrespondingto:
pre-wash,wash,rinses,drying.
Atalltimes yourdishwashertells
youwhatphaseitisat.
Modifying a wash cycle in
progress.
Ifyouhavechosenthewrongcycle
-Youcanmodifythewashcycle,if
ithasonlyjuststarted.Turnknob
"M"totheResetpositionandaftera
fewsecondsyouwillhear4beeps.
Indicatorlight"G"willgooutand3
dashes appear, this indicates all
settingshavebeencancelled.You
arenowfreeto re-set thecorrect
washcycle.
You've left out a dish?
Interruptthewashcyclebypress-
ingtheON-OFFbutton,openthe
door and insert the dish you had
forgotten,closethedoorandpress
theON-OFFbuttonagain.
Thecyclewillstartupfromwhere
youinterruptedit.
Cycle end
Theendofthewashcycleisindi-
catedby2beepsand ENDflashes
uponthedisplay.
Turnknob"M"totheResetposition
andthe3dashesforprogramming
cancellationwillappear.
Turntheapplianceoffbypressing
the ON-OFF button “A”, thus
switchingofftheelectricitysupply.
Turnoffthewatertap.
Waitafewminutesbeforeunload-
ingthedishes:theyareveryhot!If
youwaitalittlewhile,theydrybetter
due tothesteam.
Emptythelowerbasketfirst.
There's been a power
failure or you opened the
dishwasher door
The wash cycle stops and then
restartswhentheelectricitycomes
backonorwhenyouclosethedoor.
How to use your Dishwasher
How to programme “extra”
drying
If you want your dishes to be
perfectlydry,followtheinstructions
below.
Open the door, set the knob to
RESET and make any specific
settings,suchas:
- upperorlowerrack
- delayedstart
Startthewashcycleby turning
theknob:observesymbol for
drying: it will flash for about 4
seconds, while the word "OFF"
appearsonthedisplay(extradrying
disabled).
Ifyoupressbutton"I"immediately,
you will hear a prolonged beep
andtheword"ON"willappearon
the display: the extra drying has
beenenabled.
Once you have made your
selection,shuttheappliancedoor;
a beep will sound and the wash
cyclewilleitherstartimmediately
orafterthedelay,whereverset.
Rememberthatwithextradrying,
thewashcyclewilllastlonger,to
provideyouwithdrierdishes.
You decide when it starts.
Whenyouhaveloadedthedishes,
youcanchoosewhentostartyour
dishwasherbeforesettingthewash
cycledesired.Pressbutton"P"and
youcandelaythestartofthewash
cycleby1to24hours.Press the
buttononce,abeepwillsoundand
thewording"24h"willcomeupon
thedisplay.Then,eachtimeyou
pressthebuttonabeepwillsound
andthehourswilldecreasebyone
houruntilthedelay is 01h.Ifyou
press the button once again, the
delayedstartisresetand3dashes
appearonthedisplay.
Onceyouhavesetthedelayedstart
time,selectthewashcycleonthe
knob: afterthebeepsounds,you
willseeindicatorlight"H"flashon
the display and the countdown
begins(indicatedonthedisplayone
houratatime).Aquicklookatthe
indicator lights will keep you
informedofthecountdownprogress
atalltimes.
Have you changed your
mind?
During the countdown, you can
modifythedelaybypressingbutton
"P"repeatedlywithoutresettingthe
washcycle.
Ifyouhavechangedyourmindand
wish to start the wash cycle
immediately,pressbutton"P"until
the countdown is fully reset.
Indicatorlight"H"willturnoffand
thecyclewillstartatthesoundofa
beep.
Half load.
Yourdishwasheralsoallowsyou
to wash half a load (using one
basket),tosavewater,electricity
and detergent (use only half the
amount).
Beforesettingawashcycle,press
button"I".Eachtimeyoupressit,
youwillhearabeepandsymbol
(upperbasket)and
symbol (lower basket)
appearonindicator"N".Pressthe
button once more to reset the
basket selection and the
dishwasherwillagainbesettouse
bothbaskets.