HoverCam Ultra 8 User manual

Ultra8 Usermanual
The camera head maybe flipped up and downly the connecting
hinge. It can also rotate 90° counter clockwise or 270°
clockwise along the connecting hinge.
Note: When rotating or flipping the camera head, do not force
the camera head in any direction if there is resistace.

Electronic specification
1. Operation Voltage：3.0V
2. Voltage range：2.4V-3.6V
3. Operation current：<30mA
4. Standby current:：<30uA
5. Frequency: 2403-2480MHz

For Your Safety
To prevent damage to yourself or to others, read the following safety precautions in
their entirety before using this product. Keep these safety instructions where all those
who use the product will read them. The consequences that could result from failure
to observe the precautions listed in this
WARNINGS
Do not disassemble.
Failure to observe this precaution could result in fire, electric shock, or other injury.
Should the product break open as the result of a fall or other accident, remove the
batteries.
Keep out of reach of children.
Failure to observe this precaution could result in injury. In addition, note that small
parts constitute a choking hazard. Should a child swallow any part of this product,
consult a physician immediately.
Cut power immediately in the event of malfunction.
Should you notice smoke or an unusual smell coming from the product, immediately
turn the product off . Continued operation could result in injury. Once the product has
cooled, remove the batteries and take the product to a Nikon-authorized service
representative for inspection.
Do not use in the presence of flammable gas.
Failure to observe this precaution could result in explosion or fire.
Keep dry.
Do not immerse in or expose to water or rain. Failure to observe this precaution could
result in fire or electric shock.
Do not expose to high temperatures.
Do not leave the product in a closed vehicle under the sun or in other areas subject to
extremely high temperatures. Failure to observe

Federal Communications Commission (FCC) Interference
Statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generate, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate this equipment.
RF exposure warning
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment.
This equipment must not be collocated or operating in conjunction with
any other antenna or transmitter.