V1.0.20140409
CE RF Exposure Information
The SAR limit of Europe is 2.0 W/kg. Device types Huadoo HG04 has also been tested against this
SAR limit. The highest SAR value reported under this standard during product certification for use
at the ear is 0.094W/kg and when properly worn on the body is 0.356 W/kg. This device was
tested for typical body-worn operations with the back of the handset kept 1.5cm from the body.
To maintain compliance with RF exposure requirements, use accessories that maintain a 1.5cm
separation distance between the user's body and the back of the handset. The use of belt clips,
holsters and similar accessories should not contain metallic components in its assembly. The use
of accessories that do not satisfy these requirements may not comply with RF exposure
requirements, and should be avoided.
EU Regulatory Conformance
Hereby, Huadoo Bright Group Limited declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
For the declaration of conformity, visit the Web site www.huadoobright.com/certification.
Notice: Observe the national local regulations in the location where the device is to be used. This
device may be restricted for use in some or all member states of the European Union (EU)
FCC RF Exposure Information and Statement
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types Huadoo
HG04 (FCC ID: 2ACXS-HG04) has also been tested against this SAR limit. The highest SAR value
reported under this standard during product certification for use at the ear is 0.622 W/kg and
when properly worn on the body is 0.778 W/kg. This device was tested for typical body-worn
operations with the back of the handset kept 1.0cm from the body. To maintain compliance with
FCC RF exposure requirements, use accessories that maintain a 1.0cm separation distance
between the user's body and the back of the handset. The use of belt clips, holsters and similar
accessories should not contain metallic components in its assembly. The use of accessories that
do not satisfy these requirements may not comply with FCC RF exposure requirements, and
should be avoided.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s authority
to operate the equipment.