Hubbell ATS-OP-245-6-4 Series User manual

1.888.406.8906
[email protected]
py
6dBi and 7dBi Antenna Deployment
Introduction
This is a guide and explanation of the proper deployment of the AccelTex Solutions ATS-OP-245-6-4**** or
ATS-OP-245-7-6****-36. These antennas are equivalent models with different element counts.
Terms:
•6dBi antenna refers to ATS-OP-245-6-4****-36
•7dBi antenna refers to ATS-OP-245-7-6****-36

1.888.406.8906
[email protected]
Contents
1. Antenna Specifications…………………………………………………………………….3
2. 3D Radiation Pattern……………………………………………………………………….4
3. Deployment Specifications……………………………………………………………….5
a. 6dBi and 7dBi Antenna Aisle Deployment…………………………..……..5
b. 6dBi and 7dBi Antenna Free Space Ceiling Deployment……………..6
c. 6dBi and 7dBi Antenna Free Space Wall Deployment…………………6
4. Additional Help and Support…………………………………………………………….7

1.888.406.8906
[email protected]
1. Antenna Specifications
ATS-OP-245-6-4****-36
ELECTRICAL SPECIFICATIONS
Frequency Range: 2.4-2.485/5.15-5.85 GHz VSWR: ≤1.5:1, max 2.0
Gain: 6 dBi Isolation: >30 dB
Polarization: Vertical Impedance: 50 Ω
Horizontal Beamwidth: 105°/110° Lightning Protection: None
Vertical Beamwidth: 65°/55° Max Input Power: 50 W per port
MECHANICAL SPECIFICATIONS
Dimensions: 11.12” L x 4.82” H x 1.08” D (282.5x122.5x27.5mm) Radome Material: ABS
Weight: 1.5 lb (0.68 kg) Number of Leads: 4
Installation: Flush Mount to Wall or Articulating Wall Mount (included) Cable Length: 36” (910mm)
Cable Type: RG402 Plenum
ENVIRONMENTAL SPECIFICATIONS WARRANTY
Installation Environment: Indoor/Outdoor 2 Year Limited Warranty
Operating Temperature: -40 to 158°F (-40 to 70°C)
Wind Velocity: 134 mph (216 km/h)
2.4 GHZ 5 GHZ

1.888.406.8906
[email protected]
ATS-OP-245-7-6****-36
ELECTRICAL SPECIFICATIONS
Frequency Range: 2.4-2.485/5.15-5.85 GHz
Gain: 7/6 dBi
Polarization: Horizontal
Horizontal Beamwidth: 100°/110°
Vertical Beamwidth: 59°/61°
MECHANICAL SPECIFICATIONS
Dimensions: 12.6” x 6.7” H x 1.38” D (320x170x35mm) Radome Material: ABS
Weight: 1.5 lb (0.68 kg) Number of Leads: 6
Installation: Flush Mount to Wall or Articulating Wall Mount (included) Cable Length: 36” (910mm)
Cable Type: ATS-200
ENVIRONMENTAL SPECIFICATIONS WARRANTY
Installation Environment: Indoor/Outdoor 2 Year Limited Warranty
Operating Temperature: -40 to 158°F (-40 to 70°C)
Wind Velocity: 134 mph (216 km/h)
2.4 GHZ 5 GHZ

1.888.406.8906
[email protected]
2. 3D Radiation Patterns

1.888.406.8906
[email protected]
3.Deployment Specifications
When deploying 6dBi or 7dBi Antenna, there are a few main points to pay attention to. Pay close attention the
beamwidths of the antennas and blue arrows on the back of the antennas that denote the orientation of the
places. For aisle coverage, please ensure that the face of the antenna is parallel to the ground.
3.a. 6dBi and 7dBi Antenna Aisle Deployment
When deploying the 6dBi or 7dBi antenna in a warehouse aisle, you will need to mount the antenna to the
ceiling with the face pointed directly down and the vertical plane running perpendicular to the aisle you are
covering. In this orientation, the 6dBi antenna will look like the axis of the side with the leads going to the side
with the arrow is pointing at both racks in its aisle. Another way to see that orientation is that the long side of
the antenna runs along the length of the aisle.

1.888.406.8906
[email protected]
3.b. 6dBi and 7dBi Antenna Free Space Ceiling Deployment
When deploying the 6dBi or 7dBi antenna in open/free space on a ceiling, use the following guidance.
Depending on deployment height, the propagation of the antenna roughly resembles a rectangle when mount
with the face point directly downward. The orientation of this rectangle will match the orientation of the
antenna. I.E. the long side of the antenna corresponds to the longer 110˚ beamwidth of coverage while the
narrower side corresponds to the short 60˚ beamwidth.
3.c. 6dBi and 7dBi Antenna Free Space Wall Deployment
When deploying the 6dBi or 7dBi antenna in open/free space on a wall, use the following guidance. Depending
on deployment height, the propagation of the antenna roughly resembles a fan when mount with the face point
directly outward from the wall. (the face of the antenna parallel to the wall with the cable leads coming out the
bottom or top.)

1.888.406.8906
[email protected]
4.Additional Help and Support
For additional help and support, please contact us:
Phone: [phone]
Email: [e-mail]