Hubble HV-204 User manual

cabinet
manual
assembly
V 1.0

index
Assembling the Top panel, Bottom panel and Frame 3
Installing the Caster on the BOTTOM panel and the
Cover Board on the Cable Entry on the TOP panel 4
Installing the Fan Tray under the TOP panel 5
Installing the Mounting Angle 6
Installing the Mounting Prole 7
Installing the Fixed Shelf and Cover Board on the
BOTTOM panel 8
Installing the Back Door and Front Door 9
Installing the Side Panels 10
Installing the Adjustable Feet on the BOTTOm panel 11
2

3
Assembling the Top panel, Bottom panel
and Frame
Boom Panel
Frame
Top Panel
M8 Flange Nut
M8 Allen Screw
2. Using the Hex Socket set screws M8x12 to aach them.
1. Align the Top Panel and Boom Panel with the Frame.

1. Use the tapping screws M5x10 to aach the Caster to the Boom Panel.
M5x10 Pan Head
Tapping Screws
M4x8 Pan Head
Tapping Screws
2. Use the tapping screws M4x8 to aach the Cover Board on the Cable Entry
on the Top Panel.
Installing the Caster on the BOTTOM
panel and the Cover Board on the Cable
Entry on the TOP panel
4

Fan Tray
1. Use the tapping screws M5x10 to aach the Fan Tray under the Top Panel.
Installing the Fan Tray under the TOP
panel
M5x10 Pan Head
Tapping Screws
5

Installing the Mounting Angle
1. Install the Bayonet-type nut M6 on the Frame and then use the Allen screw
M6x10 to connect the Mounng Angle and Frame ghtly.
Mounng
Angle
6
Note: 4 pcs mounng angle (below 32U)
6 pcs mounng angle (above 32U)
M6 Bayonet-type Nut
Frame
M6x10 Allen Screw

Installing the Mounting Prole
Mounng
Prole
1. Install the Bayonet-type nut M6 on the Mounng Angle and then use the
Allen screw M6x10 to connect the Mounng Prole and Mounng Angle.
7

Installing the Fixed Shelf and Cover
Board on the BOTTOM panel
Fixed Shelf
1. Install the Bayonet-type nut M6 on the Fixed Shelf Mounng Prole and
then use the Allen screw M6x10 to connect the Fixed Shelf and Mounng
Prole.
2. Use the tapping screws M4x8 to aach the Cover Board on the Boom
Panel.
M4x8 Pan Head Tap-
ping Screws
8

Installing the Back Door and Front
Door
Rotaonal
Pin
2. Repeat the steps for the Front Door.
1. Install the Rotaonal Pin for the Back Rotaonal Door on the Boom Side
and then insert the Down Bolt to aim at the Hole on the Top Panel.
9

Installing the Side Panels
1. Insert the Clips in the middle of the Side Panels using two hands, and then
push the Side Panels into the Frame.
Side Panel
10
Note: The Clips must be in line with the Clip-holes of the Frame.

Installing the Adjustable Feet on the
BOTTOm panel
1. On the Boom Panel of the Cabinet, install Adjustable Feet with a wrench.
11
CONGRATULATIONS!
Once all the above steps have been completed your High Voltage Cabinet will
be ready to use!
If you have any dicules with seng up your Cabinet, please contact our
Technical Support Department via [email protected].