HumanCentric 101-1064 User manual

Model 101-1064
www.humancentric.com/patents
© 2023 HumanCentric Ventures LLC www.humancentric.com
VESA Adapter for HP M-Series Monitors
ADDITIONAL TOOLS REQUIRED
Phillips Screw Driver
M22F, M24F, M24FW, M24FD, M24FWA, M27F, M27FD, M27FQ, M27FW, M27FWA, M32F
PARTS INCLUDED
A (x1)
VESA Adapter Plate
B (x1)
Monitor Adapter
C (x5)
M4 x 12mm Panhead Screw
D (x2)
M4 x 10mm Flat Head Screw
Compatible with models:
Full product specifications: www.humancentric.com/101-1064
Need help? Contact support: [email protected]
WARNING
To reduce the risk of injury to persons, read all important precautions and warnings listed below.
HumanCentric assumes no responsibility for personal injury or property damage sustained by or through
the use of this product:
1. Read all instructions carefully.
2. Incorrect installation may lead to damage or serious injury. Ensure the product is secured before use.
3. If using a VESA stand or VESA arm, ensure it can support the combined weight of the bracket, monitor,
and any mounted devices.

1
© 2023 HumanCentric Ventures LLC www.humancentric.com
Note which geometry your monitor attachment point has and move to the next step.
2
Geometry A Geometry B
2
Orientate the Monitor Adapter (B)
with the square cutout toward the
bottom and push onto the monitor
attachment point. Make sure that
the adapter is fully pushed on and
the button is fully seated in the
square cutout. You will hear a “click”
when the button seats.
click
B

© 2023 HumanCentric Ventures LLC www.humancentric.com
3
C
Note that Geometry B is a looser fit and will
require pushing the adapter into the monitor
while tightening the screw.
Secure the Monitor Adapter onto the
monitor by tightening one of the
panhead screws (C) into the top. The
screw will stick out of the adapter even
after tightening.
4
D
A
Secure the VESA Adapter Plate (A) to the
Monitor Adapter using two flat head screws
(D). The screws should sit flush with the plate
surface in the countersunk holes.
Countersunk Holes

© 2023 HumanCentric Ventures LLC www.humancentric.com
5
Mount the monitor to your VESA
Mount using four panhead screws (C).
C