Hunza SAFETOUCH 100 LED User manual

SAFETOUCH 100 LED
INSTALLATION INSTRUCTIONS
NOTE: THESE INSTRUCTIONS MUST NOT
CONTRAVENE YOUR LOCAL ELECTRICAL AUTHORITY
REGULATIONS, WITH WHICH ALL INSTRUCTIONS
HERE IN MUST COMPLY.
PLEASE KEEP INSTRUCTIONS FOR FUTURE
REFERENCE.
Remove the complete fixture from the packaging. If the canister
and luminaire are to be installed separately detach the luminaire
from the canister and place it back in the packaging and store
securely.
If not discard the packing in an environmentally friendly way.
Dig a hole 30cm (12”) diameter and 40cm (16”)Deep. Place
drainage material in the bottom of the hole to drain away water and
stop water level build up. (See Fig. 1).
Sit mounting canister into the hole. Make sure that the top of the
canister is flush and level with the finished floor or ground level
(see Fig. 2a).
Draw the power supply cable up through the centre of the canister
ready for connection to the luminaire.
Back fill with soil or concrete. If grout is to be used with tiles insure
canister will be flush with tilt finish height.
NOTE: Do not backfill with stones, scoria or any material that
will leave air gaps next to the canister.
Concrete is strongly recommended to backfill the canister
hole. Concrete will conduct away 40% more heat than soil.
Fig. 2a
Fig. 1
For Direct bury. Make a waterproof connection with the Input
cables.
Place the luminaire into the hole. Make sure the flange is flush
with the ground level and then back fill around the luminaire.
Compact the surrounding substrate to ensure good heat
conductivity. Place drainage material in the bottom of the hole to
drain away water and stop water level build up. (see Fig. 2).
DIRECT BURY OPTION
CANISTER OPTION
Fig. 2

Once ground works are complete remove the blue flange protector.
Draw supply cable through canister and make a waterproof
connection to the luminaire input.
(See Fig.3a)
Place the luminaire into the canister. Make sure flange surfaces
are clean - dirt sand and mud free.
Tighten the two screws (A) provided that hold the luminaire into the
canister by hand only – no power tools should be used on this
luminaire. (See Fig. 4).
Make sure debris does not fall into the open luminaire while
working.
Be certain to clean gasket recess before placing Lens and Gasket
assembly into the gasket recess in the luminaire (see Fig. 4b).
Make sure that the lens and gasket are clean.
To adjust Gimbal, loosen M5 bolts, rotate to desired position and
tighten bolts to clamp Gimbal in place. (See Fig. 4a)
Place Flange on top of gasket and lens assembly and tighten
the four screws (B) evenly by hand. (See Fig. 4b).
Fig.3
Fig.3a
Fig. 4
Fig. 4a
A
Fig. 4b
B
NOTE: Where dimming is required, cut and strip
dimming cable to make connection
(White)
(BLack)
INPUT: 100-277VAC