Assembly
1
For Floor Use
2
For Wall Mount Use
□
Attach the bottom feet (B) to the upright supports (C).
Ensure the upright supports sit inside the “L”
bracket on top of the bottom feet (B). Use four sets of M6
bolts (AA), lock washers (BB) and nuts (CC) for each
upright support (C) and tighten.
□Attach three cross braces (D) to the upright supports (C)
starting at the bottom and tap down to lock into place.
□Follow step 1, but do not assemble the rack to the
bottom feet (step 1).
□Wall mount fasteners and anchors are provided. For
masonry, use appropriate fasteners.
□Fastening holes are located in upright supports. Line
up holes with studs using the storage rack as a template.
Be sure the rack is positioned level. Attach the rack to the
wall using fasteners (EE, GG, HH) and spacers (FF).
□Fasten the center support (E) to the cross braces (D) with
M4 bolts (DD).
□Install bins (A) on the cross braces (D).
NOTE: Slide bins forward and up to separate.
NOTE:
EE
HH
FF
GG
A
E
D
C
B
AA
BB
DD
CC
HUSKYTOOLS.COM
5 Please contact 1-888-HD-HUSKY for further assistance.
