Hybrid+ HF5 User manual

USER MANUAL
REV A 01-2017
HF5
PERSONAL MONITORS
www.vivaafrika.co.za
MAINTENANCE AND WARRANTY
While we have chosen the best components to make this product as rugged and reliable
as possible, some parts in audio products (potentiometers, faders, switches) are subject
to wear which is a matter of operation cycles, and not of time.
In many cases, malfunction of electro-mechanical parts occurs due to dust
contamination, which may require cleaning of such parts. As the inside of such
parts is not accessible, a common practice is to use cleaning fluids in the shape
of sprays. Please be reminded that many of such fluids contain chemicals which
may wash away the dust but at the same time corrode or damage contact
surface and may cause cosmetic damage to other parts. We hence explicitly
exclude any claims for exchange of damaged part due to mechanical
or chemical impact.
1 YEAR GUARANTEE
PLACEMENT TIPS
Avoid placing loudspeakers in the corners of a room. This increases the low-frequency
output and can cause the sound to be unclear and indistinct.
Avoid placing loudspeakers against a wall. This, too, increases the low frequency
output, though not as much as corner placement. However, if you do need to reinforce
the low frequencies, this is a good way to do it.
Avoid placing the active speakers directly on a hollow stage floor. A hollow stage can
resonate at certain frequencies, causing peaks and dips in the frequency response of
the room. It’s better to place the speakers on a sturdy table or tripod stands.
Position the speakers so the high-frequency drivers are two to four feet above ear level
to the audience to maintain high frequency quality.

USER MANUAL - HF5 PERSONAL MONITORS
PAGE 2PAGE 1
UNPACKING
Please check that the box contains the following items:
MAIN PARTS
1pc. HF5 Active Speaker
1pc. HF5 Passive Speaker
1pc. Power cable
1pc. Operation manual
* If any part is missing, please contact your dealer immediately for replacement.
USER INTERFACE ELEMENTS
Rear Side
1: Speaker In: To Connect a Slave Device
2: 3.5mm AUX In
3: Mic In
4: Tone Control
5: Vol Control
6: BT: When connected, a LED will Light Up
7: Power
8: EXT Speaker: Connection to Passive Speakers
9: Power Switch
10: Power Cord Connector - IEC Main Power Cable
250V/15A
3
2
WELCOME
Congratulations on your purchase of a Hybrid HFS speaker, engineered and designed
by Hybrid. The HF5 includes a high-output compression driver, and 5” woofer producing
an even, smooth quality sound.
IMPORTANT SAFETY INSTRUCTIONS
All operating instructions should be read before using this equipment.
To reduce the risk of electrical shock, do not open this unit. There are no replaceable
parts inside. Please refer servicing to a qualified service technician.
This unit should only be cleaned with a damp cloth. Avoid solvents or other
cleaning detergents.
When moving this equipment, it should be placed in its original carton and packaging.
This will reduce the risk of damage during transit.
Do not expose this unit to rain or moisture.
Do not use any spray cleaner or lubricant on any controls or switches.
Make sure all of your equipment is completely off and lower all volume,
level and gain controls before connecting a sound source.
Only line level signals should be sent to your speaker.
Disregarding any of the above will void your warranty!!!!
FEATURES
5’’ Full Range Active + Slave speaker System.
Bluetooth module.
Long-throw woofer with high-temperature voice coil.
Ultra-wide, smooth dispersion of high and mid frequencies.
Mic / Line input and line out , pass-through connector.
10
9
8
5
4
6
7
1