Hyco W26 User manual

User Manual
Cradle: FCC ID:2ARHS-W2X
Ring: FCC ID:2ARHS-W26

User Manual
1
Disclaimer
Disclaimer @ 2018 Hyco Genyong Technology Co., Ltd. All rights reserved.
Please read through the manual carefully before using the product and operate it
according to the manual. It is advised that you should keep this manual for future
reference.
Do not disassemble the device or remove the seal label from the device. Otherwise,
Hyco Genyong Technology Co., Ltd. does not assume responsibility for the warranty
or replacement.
The products depicted in this manual may include software copyrighted by Hyco
Genyong Technology Co., Ltd. or a third party. The user, corporation or individual,
shall not duplicate, in whole or in part, distribute, modify, decompile, disassemble,
decode, reverse engineer, rent, transfer or sublicense such software without prior
written consent from the copyright holders.
This manual is copyrighted. No part of this publication may be reproduced or used in
any form without written permission from Hyco.
Hyco Genyong Technology Co., Ltd. reserves the right to make final interpretation of
the statement above.
Hyco Genyong Technology Co., Ltd.

User Manual
2
Design
Ring Scanner
Wearing: wear on index finger on left or right hand
Scanning: touch either side of ring body with thumb finger
to trigger the scanning
Ring scanner charging cradle（Bluetooth Receiver）

User Manual
3
Charging
1. Charging Ring Scanner
Charging Illustration 1
Charging Illustration 2

User Manual
4
Connect the Ring scanner charging cradle to power, click the
ring scanner into the bottom of cradle with the scan window
upward. Please note the power contacts of the ring and
cradle must be touched.
The red light indicates it is in charging, when the green light
turns on, it’s finished charging.
Warning: don't look straightly into the scan window when
scanning in case of harm to eyes.
2. Take the Ring Scanner out of the Ring scanner charging
cradle
Hold the middle of the ring scanner gently and pull out upward
from the cradle.
Bluetooth connection
Connect with PC:
Firstly, connect the Ring scanner charging cradle with
computer via USB cable, the green light on the cradle turns
on. Secondly, after 15 seconds, Ring Scanner scans the
"Bluetooth connection" barcode on the front of cradle, the
blue light on the cradle indicates the Bluetooth

User Manual
5
communication between ring scanner and cradle is
successfully set up.
Connect with Tablet PC or phone:
Enter the “Setting ”in the Tablet PC or phone, click
"Bluetooth search", find the Bluetooth serial number of the
ring scanner, choose the corresponding Bluetooth serial
number in the searching list. When the ring light turns on
green, it indicates successful Bluetooth connection between
ring and Tablet PC or phone.
Remark: Ring Scanner is the slave, and terminal device is the
master
Use of applications (APP):
Prerequisites before connecting ring with different devices:

User Manual
6
Change connection with different masters among computer,
Tablet PC and phone.
When ring pairs with different terminal devices, user needs to
scan different barcode before Bluetooth connection.
To connect ring scanner with computer, please scan the
barcode “COMMON”, but it is set by default.
To connect ring scanner with Smart Phone or Tablet PC based
on IOS system, please scan the barcode "IOS".
To connect ring scanner with Smart Phone or Tablet PC based
on Android system, please scan the barcode "ANDROID".

User Manual
7
To connect ring scanner with Smart Phone or Tablet PC based
on Windows system, please scan the barcode "WINDOWS".
Components

User Manual
8
Specifications

User Manual
9
Functions
1. Scanning
Wear on left or right index finger, touch left or right side of ring
and aim at the barcode, the ring light turns green, it starts to
scan.
2. Ring Straps
Firstly, straightly pull out ring strap from the slot, then choose
another ring strap and push it to the top of slot.
3. Ring Indicator