Hyundai power products HYVI10030 User manual

1
INDUSTRIAL WET / DRY VACUUM CLEANER
HYVI10030
Instruction Manual

2
HYUNDAI
IMPORTANT: DONT FORGET TO REGISTER YOUR EXTENDED
3 YEAR HYUNDAI WARRANTY WITHIN 30 DAYS OF PURCHASE.
https://www.hyundaipowerequipment/warranty
1. On/off switch motor 1
2. On/off switch motor 2
3. On/off switch motor 3
4. Motor housing
5. Hose connection
6. Container
7. Container latch
8. Hose
9. Telescopic tube
10. Nozzle
11. Wheels
12. Trolley

3
2
1
3
8
9
5
4
6
7
11 12
10
A

HYUNDAI
4
B

5
INDUSTRIAL WET/DRY VACUUM
CLEANER
HYVI10030
WARNING
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, re and/or serious injury. Save all warnings and
instructions for future reference.
SAFETY WARNINGS
When using the machine, always observe the enclosed safety
warnings as well as the additional safety warnings.
The following symbols are used throughout this manual:
Denotes risk of personal injury or damage to the machine.
SAFETY INSTRUCTIONS FOR WET/DRY VACUUM
CLEANERS
• Use original accessories only.
• When picking up liquids, only use the accessories intended for
this purpose.
• Do not pick up substances which adhere to the filter, such as
lime, powder, Gesso and graphite powder. The dust can block
the ventilation and damage the engine.
• Do not use the machine to pick up burning or smouldering
debris, explosive or inflammablesubstances and liquids.
• Do not allow the machine to tip over, as this may cause water to
enter the engine and damage it.
• Switch the machine off and remove the plug from the socket
after use.
• Keep the machine away from bright sunlight and high
temperatures.
• Keep body parts away from the vacuum opening when the
machine is running.
ELECTRICAL SAFETY
Always check that the power supply corresponds to the
voltage on the rating plate.
DESCRIPTION (FIG. A)
Your wet/dry vacuum cleaner has been designed for picking up dry
dust and debris as well as liquids.
1. On/off switch motor 1
2. On/off switch motor 2
3. On/off switch motor 3
4. Motor housing
5. Hose connection
6. Container
7. Container latch
8. Hose
9. Telescopic tube
10. Nozzle
11. Wheels
12. Trolley
Package contents
The package contains the following parts:
Wet/dry vacuum cleaner
Trolley
Hose
Telescopic tube
Dry floor brush
Wet floor brush
Crevice nozzle
Brush nozzle
HEPA Filter
Dustbag
MOUNTING THE TROLLEY (FIG B)
MOUNTING THE ACCESSORIES (FIG. A)
Before mounting an accessory, always unplug the
machine.
Connecting the hose (g. A)
• Insert the end of the hose into the hose connection until it clicks
into place.
• Place the suction tube (9) on the other end of the hose.
• Place a mouthpiece on the other end of the tube.
• Switch on the machine.
Mounting accessories for picking up dry material (g. A)
The dustbag must be used for picking up dry material.
• Remove the motor housing (3) from the container (7) by
releasing the container latches (8).
• Remove the intake filter by sliding it off the float.
• Place the dustbag in the container and slide it firmly over the
hose connection (9).
• Replace the motor housing and click the container latches firmly
shut.
• Connect the hose (10) to the hose connection (9).
NOTE: In order to ensure proper filtering when vacuuming dust
and dry material the intake filter needs removing and the
dustbag needs to be put in its place. The intake filter is only to
be used vacuuming liquids.
Mounting accessories for picking up liquids (g. A)
The intake lter must be used for picking up liquids.
• Remove the motor housing (3) from the container (7) by
releasing the container latches (8).
• Slide the intake filter over the float.
• Remove the dustbag from the container.
• Replace the motor housing and click the container latches firmly
shut.
• Connect the hose to the hose connection.
NOTE: Remove all dirt and debris from the tank. A intake filter
must be used to vacuum up wet debris. Unplug the power cord
from the wall outlet before removing the motor assembly from
the tank. Turn the motor over.
Remove the dust collection bag and install the intake filter.
Blower function
Connect the hose to the hose connection on the backside to switch
from blowing to blowing.
Always switch off the piston when changing function.

6
ENVIRONMENT
Disposal
Your product, accessories and packaging should be sorted for
environmental-friendly recycling.
Only for EC countries
Do not dispose of power tools into domestic waste. According to the
European Guideline 2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national right, power tools
that are no longer usable must be collected separately and disposed
of in an environmentally friendly way.
Subject to change; specications can be changed without further
notice.
SWITCHING ON AND OFF (FIG. A)
This wet/dry vacuum cleaner is equipped with three motors so you
can increase the suction power as needed.
Before switching on the machine always check that the
lter has been tted. Sucking without a lter can seriously
damage the engine.
• Plug the mains plug into an outlet.
• Start the first motor by setting the on/off switch (1) to position ‘I’.
• If desired, start the second and third motor by turning the on/off
switches (2 and 3) to position “I”.
• Switch off the machine by setting the on/off switches to position
‘0’.
The machine is equipped with an overow oat which ensures that
the suction power stops when the tank gets too full and a warning
signal sounds. Switch off the machine, empty the tank and switch on
the machine again.
CLEANING AND MAINTENANCE
The machine does not require any special maintenance.
Always remove the plug from the mains outlet before
cleaning the machine or performing maintenance to the
machine.
• Wash the filter with warm water and a mild detergent.
• Let the filter dry thoroughly after each use.
• Empty the container each time after using the machine to pick
up liquids. Allow the container to dry thoroughly afterwards.
• Regularly clean the container using soap and water. Allow the
container to dry thoroughly afterwards.
• Regularly clean the motor housing using a non-fluffy cloth or
brush.
HYVI10030
V 230
Hz 50
W 3,000
l 100
dB(A) 82
TECHNICAL DATA
Mains voltage
Mains frequency
Power input
Container capacity
LpA (sound pressure)*
Weight kg 27.5/24.5
*Level of sound pressure in the workplace.
WARRANTY
Register your 3 year warranty within 30 days of purchase
at:
https://hyundaipowerequipment.co.uk/warranty
Full warranty term and conditions can be found on the
HYUNDAI website:
www.hyundaipowerequipment.co.uk

7
GENPOWER LTD confirms that this HYUNDAI POWER PRODUCT conforms to the following CE Directives:
EN62233:2008
EN60335-1:2012+AC:14+A11:14
EN60335-2-82015
EC DECLARATION OF CONFORMITY
The undersigned, as authorised by: Genpower Ltd
Declares that the following equipment manufactured under license by Hyundai Korea
Conforms to the Directive:
EN62233:2008
EN60335-1:2012+AC:14+A11:14
EN60335-2-82015
Of the European Parliament and of the council on the approximation of the laws of the Member States relating to the noise
emission in the environment by equipment for use outdoors.
Equipment Category:
Product Name/Model:
Type:
Mains Voltage:
Input Power:
Capacity:
The technical documentation is kept by:
Power Tools
HYVI10030
Industrial Wet / Dry Vacuum Cleaner
3000W
230V
100L
Roland Llewellin, Genpower Ltd,
Isaac Way, Pembroke Dock,
Pembrokeshire, SA72 4RW.
The conformity assessment procedure followed was in accordance with annex V or VI of the Directive.
Notified Body:
Certification No:
Measured Sound Power Level:
Guaranteed Sound Power Level:
Yongkang Jienuo Industry Trade Co, Ltd
Xialixi Industrial Zone, Yongkang City, Zhejiang Province, P.R. China
160400927HZH-001/A1
82 dB (A)
82 dB (A)
A copy of this certificate has been submitted to the European Commission and to EU Member State United Kingdom.
Place of Declaration: Pembroke Dock, SA72 4RW
Date: Tuesday, 06 August 2019
Signed By: Roland Llewellin
Position in Company: Managing Director
Name and address of manufacturer or authorised representative:
Genpower Ltd, Isaac Way, Pembroke Dock, Pembrokeshire, SA72 4RW.

Licensed by Hyundai Corporation, Korea
Imported for:
GENPOWER LTD
Isaac Way, London Road,
Pembroke Dock, UNITED KINGDOM, SA72 4RW
T: [phone] F: [phone]
E: [email protected]
www.hyundaipowerproducts.co.uk
Imported/Distributed by Genpower Ltd for The United Kingdom & Ireland