Operating Instructions
Inner Cover
Model No. WV-Q161
Before attempting to install this product,
please read these instructions carefully
and save this manual for future use.
The model number is abbreviated in some descriptions
in this manual.
Inner cover
+
Put on until a click is
heard
Cover
Hook
Be sure to read "Precautions" before installation.
How to engage the inner cover
Slide the covers located on the both lateral sides of the
camera and put the inner cover on the camera until the
hooks inside the inner cover are engaged in the holes of
the camera (until a click is heard).
Important:
• Put the inner cover down on the camera until the
outside cover of the camera cannot be seen from
the opening (from which the camera lens is visible)
of the inner cover.If this engagement work is not
successfully performed, the inner cover may be
removed or the hidden part at the top of the screen
may become larger in the wide mode.
• When the inner cover with this product and a dome
housing equipped is mounted, the clearance
between this product and the housing shall be
2mm or more.
This product is an inner cover that is exclusively
designed to be used with the network cameras. Refer to
the catalog or the installation guide of the camera for
supported cameras.
This inner cover is a component to lower the reflection
of the dome part of the network camera.
Preface
• Be sure to engage the inner cover onto the
camera main body before installation of the
camera main body.
Failure to observe this may cause a drop resulting in
injury or accidents.
• Refer installation work to the dealer.
Installation work requires skills and experiences.
Failure to observe this may cause fire, electric
shock, injury, or damage to the product. Be sure to
consult the dealer.
Precautions
Installations
Clearance of 2 mm
or more
