ibis SiViB Display User manual

Revision 07/2003
SiViB Record Display
Operating Instructions

IBIS GmbH SiViB Record Display Manual Page 2
IBIS Ingenieurbüro für Instandhaltungs- und Schwingungsmeß-Systeme GmbH
Reinheimer Str. 17, 64846 Groß-Zimmern, Germany; www.ibis-gmbh.de
Tel. [phone], Fax [phone], Email: [email protected]
Description
SiViB Record Display is to be used for displaying measurement values acquired by a SiViB Record
1500 series monitor.
Mounting
Mount the display in a front panel through a cut out of 138 x 68 mm.
Fix the instrument from the back side using the clamps and screws, which are provided as
standard accessory.
Connections
Power supply: 24 Volts DC +/- 10%, consumption approx. 200 mA
RS232C serial connection to SiViB Record monitor.

IBIS GmbH SiViB Record Display Manual Page 3
IBIS Ingenieurbüro für Instandhaltungs- und Schwingungsmeß-Systeme GmbH
Reinheimer Str. 17, 64846 Groß-Zimmern, Germany; www.ibis-gmbh.de
Tel. [phone], Fax [phone], Email: [email protected]
Operation
On power on, the display sends a request for data to the connected SiViB Record monitor. First the
type / model of monitor is checked. This gives the display the necessary information which units to
show on the LCD screen.
Normally the display is pre configured to enter one of the measurement value display screens
automatically. The display unit asks the monitor for fresh data approx. once per second, calculates
the engineering units and displays the values.
Screen modes
The display has 3 screen modes
The third screen mode „changing display“is similar to the second. It shows the block graph as
above, but switches through all available channels automatically.
This mode is available for some instrument versions only.
Overview
All values in one
screen as digital
numbers
Block
graph
Digital numbers and a
block graph for 2 units
at a time

IBIS GmbH SiViB Record Display Manual Page 4
IBIS Ingenieurbüro für Instandhaltungs- und Schwingungsmeß-Systeme GmbH
Reinheimer Str. 17, 64846 Groß-Zimmern, Germany; www.ibis-gmbh.de
Tel. [phone], Fax [phone], Email: [email protected]
Configuration
If you need to make changes to the pre configured operation mode, use the pushbuttons labelled
with arrows.
Up arrow:
Leave display screen to menu
Move one menu level up
Enter arrow:
Select an option
Go to a lower menu level
Down arrow:
Skip through the options of the current menu level
You can set up:
Menu language, display mode, some units calculations (depending on SiViB Record type),
communication port, CAN-Bus parameters.
Please note that any changes made to the configuration have to be stored in the display’s
non volatile memory, if you want them to come back after a power loss.
Select „store config“from the highest menu level.
Changes in the communications and CAN-Bus parameters get effective after a power cycle.