ICG IC2 Instructions for use

BNelson 1.2016BNelson 1.2016
IC3 & IC2
Preventive Maintenance
BNelson 10.2015

BNelson 1.2016BNelson 1.2016
The maintenance and care procedures must be performed regularly to
ensure maximum operating safety and lifespan.
Irregularly observed maintenance and care procedures will lead to
increased wear to the product.
Preventive Maintenance

BNelson 1.2016BNelson 1.2016
What types of maintenance are there?
Daily Maintenance
Weekly Maintenance
Bi-Weekly Maintenance
Monthly Maintenance
User-Defined Maintenance
These intervals are defined based on a daily use of 3 – 4 hours daily or 25
hours a week. Depending on use, the service intervals may have to be
adjusted.
Preventive Maintenance

BNelson 1.2016BNelson 1.2016
Daily Maintenance
Wipe down the bike after each use with
disinfectant where the rider comes into
contact with or bodily residues can be
found.
Seat
Handlebars
Shrouds/Frame
Preventive Maintenance

BNelson 1.2016BNelson 1.2016
Daily Maintenance
Adjust the feet of the bike to
prevent it from rocking during use.
Preventive Maintenance

BNelson 1.2016BNelson 1.2016
Daily Maintenance
We suggest cleaning the complete
bike with a *soap and water solution
once a day.
*Soap and water solution: 1:10 soap to
water. Soap can be a mild antibacterial dish
soap.
Preventive Maintenance
Never spray anything on the flywheel when
it is in motion!

BNelson 1.2016BNelson 1.2016
Weekly Maintenance
Before you start the weekly cleaning of
the bike, open the levers for the height
adjustment of the seat and handlebar. Lift
the handlebar and seat into their
maximum position.
Preventive Maintenance

BNelson 1.2016BNelson 1.2016
Lubricants and Grease
We recommend using Super Lube
aerosol with PTFE as a lubricant as well
as Super Lube grease with PTFE when
performing the weekly cleaning and
lubrication of your IC2 & IC3 Indoor
Cycle.
Preventive Maintenance
We recommend using WD-40 to
lubricate the felt brake pad and to
clean the flywheel.

BNelson 1.2016BNelson 1.2016
Weekly Maintenance
Spray *soap and water solution onto
a soft cloth and clean the entire bike:
*Soap and water solution: 1:10 soap
to water. Soap can be a mild
antibacterial dish soap.
Preventive Maintenance

BNelson 1.2016BNelson 1.2016
Weekly Maintenance
Spray Super Lube aerosol onto a
soft cloth and clean:
Stem and seat height adjustment
It is very important to remove any
residue from the stem and seat
adjustment. The maintenance spray
also lubricates the adjustments for
smooth and easy extension and
compression.
Preventive Maintenance

BNelson 1.2016BNelson 1.2016
Weekly Maintenance
Spray WD-40 onto a soft cloth and
clean:
Flywheel
Cleaning with WD-40 will remove
residue and prevent oxidation.
NEVER SPRAY MAINTENANCE
SPRAY OR ANYTHING ELSE
DIRECTLY ON THE FLYWHEEL!
Preventive Maintenance

BNelson 1.2016BNelson 1.2016
Bi- Weekly Maintenance
Emergency break test
To ensure operating safety, the
emergency brake must be tested to
make sure it is operating properly.
Preventive Maintenance

BNelson 1.2016BNelson 1.2016
Bi- Weekly Maintenance
Slider lubrication
Push the slider into the forward position.
Wipe off any residue with a clean cloth.
Grease the following with Super Lube
grease.
a) Inside the notch
b) Bottom flat surface
c) Top flat surface
Push the slider into the opposite position
and repeat equally lubricating both sides of
the slider
Preventive Maintenance
ABC

BNelson 1.2016BNelson 1.2016
Bi- Weekly Maintenance
Brake Pad
Lubricate the entire brake pad using WD-
40. This will be sure that the bike gives all
levels of resistance.
How to video:
https://youtu.be/ozVNxWmPCfQ
Preventive Maintenance

BNelson 1.2016BNelson 1.2016
Monthly Maintenance
Bolts should be checked if they
have loosened over time.
Seat 25 Nm
Crankshaft 60 Nm
Pedals 55 Nm
Levelers Hand tight
The Levelers should be tested if
they are easy to adjust. They
should then be turned all the way
back in.
Preventive Maintenance

BNelson 1.2016BNelson 1.2016
Monthly Maintenance
SPD system
Lubricate pedal clips and pedal
axle (spindle) with a small
amount of Super Lube aerosol.
Preventive Maintenance

BNelson 1.2016BNelson 1.2016
Monthly Maintenance
Handlebar and seat post adjustment
knobs
Unscrew and lubricate the handlebar and
seat adjustment knobs with a small
amount of WD-40.
Preventive Maintenance

BNelson 1.2016BNelson 1.2016
As Needed Maintenance
Horizontal Locking Levers
Re-align the seat post and handlebar
levers to match graphic. This will be sure
that the levers are out of the users way
when riding.
Attention:
Never use force to over-tighten the levers
as they can break
Preventive Maintenance