ICM Controls CPLCCT-SLM User manual

1) A. Before prepping the cable,cutthe cable atarightangle tothe jacket.
B.Expose1/4” center conductor and 1/4”dielectric asshownin Figure 1.
UseStrip Tool PS59/6/RGB or —-
For the 1RGB (orange connector) strip the center conductor to18 AWGand the
dielectricto14 AWGusing awire stripping tool.
For the 1.5RGB (purple connector) strip thecenter conductor to14 AWGand the
dielectricto10 AWGusing awire stripping tool.
www.icmcorp.net
CABLESERIES: RGB
TOOL:CPLCCT-SLM
TIP:SILVERORGOLD
STRIPPER:PS59/6/RGB
FIGURE1
F-CONNRCAFORRGB

2) Insertthe plastic
guide ontothe center
conductor as shown
FIGURE2
FIGURE3
FIGURE4
3) Insertthesleeveovertheplastic guideuntil it
coversthebraid that wasfolded over during initial
preparation asshownin figure 3.
4) Holding the cable with
sleeve&plasticguide firmly,
insert the tipas shownin figure 4

FIGURE6
FIGURE5
5) Inserttheassembled cable withsleeveintothe connector housing asshownin figure 5.
6) Crimpthe connector asshownin figure 6.

7)Installthe color ring ontothe connector
as shownin figure 7.
FIGURE7
CPLCCT-SLMToolInstructions
InserttheappropriatetipintotheBNCspringclip
beforeinsertingtheRCAconnector.Insertthetip
sothat theslotopeningfacesup.Thetipcanbe
storedonthebottomofthetoolbyscrewingit in
placeontheundersideof thebody.
Graspthebodyof the toolwithyourfingersand
start toclosethehandleofthetool. Asthehandle
closes,the plungerslidestowardstheyoke.When
the handleiscompletelyclosedagainstthebody,
the connectorhasbeenterminated.