PTT SWITCH CABLE
INSTRUCTIONS
OPC-2359
Thank you for choosing this Icom product.
You can use the OPC-2359 p t t s w i t c h c a b l e to connect a
headset to a transceiver.
Please read these instructions thoroughly before using
the OPC-2359.
PRECAUTIONS
• NEVER place any heavy object on the cable, or pinch it.
• DO NOT drop the cable on a hard surface. If the switch
case is deformed, strained, or cracked, the protection
against dust and water may not be maintained.
• DO NOT expose the cable to direct sunlight. It may
deform or discolor the cable.
• BE CAREFUL ! Some fabric might be damaged by using
the clip.
• BE SURE to turn OFF the transceiver’s power before
attaching or detaching the headset. Otherwise a
malfunction may occur, or it may damage the transceiver,
headset, or the cable.
• USE with only the specified Icom transceiver or headset.
Otherwise it may damage the transceiver, headset, or
cable.
• KEEP the cable out of the reach of children.
FEATURES
• The cable meets IP54 requirements for dust-protection
and splash resistance. (Except for the headset connector)
• Easily enable the PTT switches by touch.
• Status indicator is equipped for the PTT Toggle switch.
• Compatible with full duplex* communication.
*Setting is required.
DESCRIPTION
The optional headset, HS-102, is required.
A-7222H-2EX
© 2015 Icom Inc.
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
NOTE: Adjust the microphone gain if called stations have difficulty hearing your voice. Refer to the instruction
manual of your transceiver for details or contact your Icom dealer or distributor for advice.
Power supply requirement:
Supplied by the transceiver
Dimensions:
22.5 (W) × 56.0 (H) × 12.5 (D) mm;
0.9 (W) × 2.2 (H) × 0.5 (D) inches
(cable, bush and rotary clip are not included)
Weight (Approximately):
44 g; 1.6 oz
Cable Length (Approximately):
100 cm; 39.3 inches
All stated specifications are subject to change without
notice or obligation.
SPECIFICATIONS
OPC-2359
PTT Toggle switch
Push to toggle between transmit and
receive.
The status indicator lights red while
transmitting.
PTT Push switch
Push to transmit, release to receive
Disabled while the status indicator is lit.
Status indicator
When the PTT Toggle switch is:
Set to transmit: Lights red
Set to receive: Does not light
The indicator does not light when the
PTT Push switch is only pushed.
Rotary Clip
Easily attached to your pocket or collar.
Transceiver
(Refer to the Icom
website for compatible
transceivers.)
Headset (Option)
Icom, Icom Inc. and Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the United Kingdom,
Germany, France, Spain, Russia, Australia, New Zealand, and/or other countries.
The crossed-out wheeled-bin symbol on your
product, literature, or packaging reminds you
that in the European Union, all electrical and
electronic products, batteries, and accumulators
(rechargeable batteries) must be taken to designated
collection locations at the end of their working life. Do not
dispose of these products as unsorted municipal waste.
Dispose of them according to the laws in your area.
DISPOSAL
Firmly insert the OPC-2359 into
the [MIC/SP] jack. It is needed to
maintain the IP54 dust-protection
and splash resistance.
