ICP DAS USA UA-2241M User manual

1
UA-5200 Series Quick Start
The shipping package contains this document and the following
items:
UA-2241M
MicroSD 卡
CA-0910
Cable
Pin Terminalx 16
Screw Driver
[Technical Support]
UA Series User Manual:
http://ftp.icpdas.com/pub/cd/UA-
Series/user_manual/UA-5231_UA-2241
ICP DAS Website: http://www.icpdas.com
Technical Support E-Mail: [email protected]
What’s in the box?
UA-2200 Series Quick Start
English / v1.0 / Apr. 2019

2
UA-5200 Series Quick Start
1. Power Supply: +12 ~ +48 VDC (Ex: DP-665)
2. Ethernet Hub or Switch (Ex: NS-205)
3. PC/NB: Can connect to the network and set the network
Connect the UA-2200 with the RJ-45 Ethernet port to an
Ethernet hub/switch and PC. You can also link directly the
UA-2200 to PC with an Ethernet cable.
After power is connected, please【wait 1 minute】for UA-2200
start-up procedure. When the "RUN" "PWR" lights start flashing,
it represents the boot is complete.
Preparations for Devices
Hardware Connection
Power Supply
(12 ~ 48 VDC)
VS+
GND
Ethernet
Cable
Ethernet
Cable
Hub/Switch
P.GND
PWR
LAN1

3
UA-5200 Series Quick Start
Factory Default Settings of UA-2200
Network
IP LAN1
LAN2
192.168.255.1
10.0.0.1
Assign UA-2200
a new IP setting
according to your
case.
Netmask
255.255.0.0
Gateway
192.168.1.1
OS
Account
Username
root
After login,
change your
password ASAP.
(Refer User
Manual)
Password
icpdas
Web UI
Account
Username
root
Password
root
1. Change the PC’s IP setting as following.
(Write down the PC original network settings before modify.)
IP
192.168.255.10
Subnet mask
255.255.0.0
Gateway address
192.168.1.1
2. Make sure the PC and UA-2200 is connecting through
Ethernet. And then open a PC side browser. (Ex: Chrome,
IE…)
Network Connection

4
UA-5200 Series Quick Start
3. Type http://192.168.255.1 in the URL address. Use default
Web UI username/password root/root to login the system.
4. Click【System Setting】【Network Setting】【Network
Setting(LAN1)】to change the IP setting by user network.
5. Save the IP setting, restore the PC original IP settings, and
type the new IP in the browser as step-3 to login the Web UI
of UA-2200. And then configure user’s UA project.