ICP DAS USA UA-7200 Series User manual

P.1
Packing List
The shipping package includes this document and the following items:
UA-7231M
Pin Terminal x 16
MicroSD Card
Screw Driver
Technical Resources
How to search for drivers, manuals and spec information on ICP DAS website.
For Mobile Web
For Desktop Web
UA-7200 Series Quick Start
v1.1, 01/2023
Technical Support
[email protected]
https://www.icpdas.com

P.2
1. Preparations for Devices
Prepare one UA-7200, Ex: UA-7231M, and the following:
1. PC/NB: Can connect to the network and set the network
2. Ethernet Switch (Ex: NS-205A or PoE Switch NSM-208PSE )
3. Power Supply: +12 ~ +48 VDC (Ex: MDR-60-24)
2. Hardware Connection
Connect the UA-7200 with the RJ-45 Ethernet port to an
Ethernet switch/hub (Fig.2 for PoE Switch) and PC. You can
also link directly the UA-7200 to PC with an Ethernet cable.
After power is connected, please【wait 1 minute】for UA-7200
start-up procedure. When the "RUN" light starts flashing, it
represents the boot is complete.
PoE Switch/Hub
UA-7200
Cable
Cable
Power Supply
Fig.2
Switch/Hub
UA-7200
(R)+V
S
(P)GND
Cable
Cable
Power Supply
+ V
Power Supply
12 ~ 48 VDC
-V
Fig.1

P.3
3. Network Connection
UA-7200 Factory Default Settings
Network
IP
192.168.255.1
Assign UA-7200 a
new IP setting
according to your
case.
Mask
255.255.0.0
Gateway
192.168.1.1
Web UI
Account
Username
root
After login, change
the username /
password to use
other functions.
Password
root
1. Change PC’s IP setting to be in the same network with UA.
Ex: (Write down the PC original IP settings before modify.)
IP
192.168.255.10
Subnet mask
255.255.0.0
Default gateway
192.168.1.1
2. Make sure the PC and UA is connecting through Ethernet.
And then open a PC side browser (Ex: Chrome, IE…). Type
http://192.168.255.1 in the URL address. Use default
Web UI username/password root/root to login the system.

P.4
3. Change the default Username/Password in the 【System
Setting】【Account Setting】to use other functions.
4. Click 【System Setting】【Time Setting】, check if the UA
time is correct. If not, modify or set Time Synchronization.
5. Click【System Setting】【Network Setting】【Network
Setting(LAN1)】to change the IP setting by user network.
6. Save the IP setting, restore the PC original IP settings, and
type the UA new IP in the browser to login the Web UI of
UA-7200. And then configure user’s UA project.