IDZOR HPRT-HT100 User manual

Quick Start Guide
Appearance and Components Loading the Roll
PR-600 Series
Power Cord
Quick Start Guide
Printer AC Adapter
CD
Quick Start Guide
Front View
Rear View
Inside View
Printer Cover
Feed Buon
Cover Open Levers
(Status Indicator)
Platen
Locking Tab
Moveable Label Guides
Kick-stand Cover Lock
Printhead Module
Moveable Roll Holders
Moveable Label Sensor
Power Switch
Power Receptacle
USB Port
Serial Port
Ethernet Port
HPRT-HT100
USB Cable Label Roll Ribbon
Note: The views above are for your reference. Ports vary
by your choice.
！
Rev.1.0 -1-
1.Pull and li the cover.
2.Pull the roll holders open and place the roll between
them.
！Note: The packing materials are actually based on the order.

Loading the Ribbon
Connecng the Power
3.Press down the locking tab. 4.Pass the labels through label guides and adjust label guides
to label’s width.
1.Aer pung rewind spindle through printhead module, insert the right side of supply spindle into the rear pin, and then insert the
le side into the rear wheel. Then do the same procedure for the ribbon rewind spindle.
Ribbon Supply Spindle
Ribbon Rewind Spindle
Rear Ribbon Pin
Front Ribbon Pin
2.Rotate the front ribbon wheel unl the ribbon is pulled ghtly. 3.Press the lock and close the cover slightly.
4.Press down the cover unl it snaps closed. 1.Make sure the printer’s power switch is in the off posion.
2.Connect the AC adapter to power receptacle.
3.Connect the power cord to AC adapter.
4.Connect the other end of power cord to the outlet.
！Note: Please refer to windows driver installaon in
PR-600 Series HPRT-HT100 User Manual.
Rev.1.0 -2-
AC Adapter
Power Cord
OFF ON
1
2
4
3
Varies by regions
Rear Ribbon Wheel
Front Ribbon Wheel