1
2
Press the spring latch to
hide the power strip under
the desk while not in use.
Insert the power column into the cut-out hole located in the desktop and then tighten the locking ring
under the desk.
Mark a hole position on the desktop as shown and drill the hole using a power drill with a 60mm (2.4")
diameter hole saw. Prior to cutting the hole, ensure the area below the desk is clear of any objects
such as wire or cable.
min50mm
min50mm
max30mm
ø60mm
Note: To prevent possible personal
injury or property damage, ensure
that the device is disconnected from
the mains before installation.
