Ikegami ICD-E11 User manual

TROUBLESHOOTING
1. When the image does not appear on the screen, check the power source for the monitor and camera.
Make sure that the voltage and polarity are properly connected and correctly supplied.
2. When the image is too dim, check if the lens is stained.
If dirty, clean the lens with a clean soft cloth. If clean, adjust the back focus of the lens.
3. When the camera does not work properly, the camera housing is too hot or black lines appear on the screen,
check if you have connected the camera to a proper power source. If there is no problem with
the power connection, turn the camera off immediately and contact our service department for assistance.
4. When the screen blinks too much, check if the camera is facing directly toward the sun or a fluorescent light.
If so, adjust the angle or location of the camera.
WARRANTY
1. Products are supplied with 3 year limited warranty from the date of purchase.
We will repair or replace the defective item with a new or factory rebuilt replacement.
2. Transportation of the product to our service center is the responsibility of the user.
Repaired or replaced product will be returned prepaid during the warranty period.
3. This warranty applies to the original purchaser only.
4. This warranty will be invalid if unauthorized repair or modifications are made to the unit or in any
case of accident, misuse or damage caused by improper installation or altered serial numbers.
5. The liability of the company has limited the cost of repair/replacement of the unit under warranty.
6. If you need warranty service, please return the product to your distributor/dealer.
Proof of pruchase may be required.
WARRANTY CARD
FEATURES
ICD-E11
MINI CORNER MOUNT
CAMERA
1/3"SonySuperHADIICCD
ROHS 3-AXIS DAY & NIGHTBoard Lens
User's Manual
WARRANTY CARD
FEATURES
-High Resolution 630TV Lines
-Fixed Board Lens (Options)
-Corner Mount Camera (IP66)
-0 Lux for Infrared Lighting Conditions
Ikegami Electronics (U.S.A.), Inc.
37 Brook Avenue, Maywood, N. J. 07607-1195
ph: [phone] fax [phone]
[URL: www.ikegami.com]
PRODUCT NAME
DATE OF PURCHASE
WARRANTY DATE
ADDRESS OF CUSTOMER
CONTACT
- Please read the instruction manual again before askingfor the A/S
- Please explain exacity what the problem you have is,
NAME
TEL
NAME
AGENT
TEL
WARRANTYYEAR
/ DAY /M /Y 3YEAR

ITEM NTSC PAL
Total Pixels 811(H) x 508(V) 795(H) x 596(V)
Effective Pixels 768(H) x 494(V) 752(H) x 582(V)
Sensor
1/3
"
Sony Super HADII CCD
SPECIFICATIONS
SETTING& INSTALLATION
Caution : Please Use Regulated DC 12
V
<DIMENSION>
Sensor
Scanning System 2:1 Interlace
Frequency
Horizontal :15.734KHzVertical : 59.94Hz Horizontal :15.625KHzVertical : 50.00Hz
Resolution More than 630 TV Lines
Video Output 1.0Vp-p Composite Signal ( 75ohm )
AGC
S/N (Y signal)
Min.Illumination
White Balance
Electronic shutter speed 1/60s - 1/100,000s 1/50s - 1/100,000s
3D-DNR ON
D&N Selection EXT
BLC OFF
D-WDR OFF
HLM OFF
Defect Pixel Compensation
IR SMART OFF
Motion Detection OFF
Privacy Masking OFF
MIRROR OFF
SHARPNESS OFF
IR LEDs 6 IR LEDs
Lens Mount 2.97mm Fixed Board Lens
Operating temperature/Humidity -10℃~+50℃/ 0~80% RH
Power Supply DC12V 110mA (CDS ON : 170mA)
Dimensions 120(H) x 120(W) x 90(D)mm
Weight Appx. 320g
1/3 Sony Super HADII CCD
E
L
E
C
T
R
I
C
A
LOFF
ON
52dB or more (AGC OFF)
0 Lux for Infrared Lighting Conditions
ATW
CONNECTOR ACCESSORIES
▶Screw for fixing
▶L-Wrench
[ Unit : mm ]
When you install the
camera, please glue up the
end of cable to keep it
stable in order to protect the
camera from the humidity
problems.
!