IMG LIGHTING WIND User manual
TO CREATE IMPRESSIVE RESULTS
img-lighting.ru
第 1 页 共 1 页
11AAiinnssttaallllaattiioonnmmaannuuaall
IInnssttaallllaattiioonn：：
1.Loosen the M5 screws
and remove the lamp
support.
2. Drill four holes on the wall or
floor according to the hole position
of support, and put rubber plugs or
wood blocks into the holes
3. Fix the lamp support with
M4*25 screws
4、、Connect power cord to
the power cable of the
lamps, and then tie it with
waterproof tape (waterproof
measures must be taken)
5、、Put the long cable in place,
align the installation card of the
lamp with the position of the
support, and lock the screws.
第 1 页 共 1 页
11AAiinnssttaallllaattiioonnmmaannuuaall
IInnssttaallllaattiioonn：：
1.Loosen the M5 screws
and remove the lamp
support.
2. Drill four holes on the wall or
floor according to the hole position
of support, and put rubber plugs or
wood blocks into the holes
3. Fix the lamp support with
M4*25 screws
4、、Connect power cord to
the power cable of the
lamps, and then tie it with
waterproof tape (waterproof
measures must be taken)
5、、Put the long cable in place,
align the installation card of the
lamp with the position of the
support, and lock the screws.
1.Loosen the M5 screws
and remove the lamp
support.
2. Drill four holes on the
wall or oor according
to the hole position of
support, and put rubber
plugs or wood blocks into
the holes.
3. Fix the lamp support
with M4*25 screws.
第 1 页 共 1 页
11AAiinnssttaallllaattiioonnmmaannuuaall
IInnssttaallllaattiioonn：：
1.Loosen the M5 screws
and remove the lamp
support.
2. Drill four holes on the wall or
floor according to the hole position
of support, and put rubber plugs or
wood blocks into the holes
3. Fix the lamp support with
M4*25 screws
4、、Connect power cord to
the power cable of the
lamps, and then tie it with
waterproof tape (waterproof
measures must be taken)
5、、Put the long cable in place,
align the installation card of the
lamp with the position of the
support, and lock the screws.
4. Connect power cord
to the power cable of the
lamps, and then tie it
with waterproof tape (wa-
terproof measures must
be taken).
5. Put the long cable in
place, align the installa-
tion card of the lamp with
the position of the sup-
port, and lock the screws.
