IMPACT ACOUSTIC Chatpod 185 User manual

185
Chatpod
ASSEMBLY INSTRUCTIONS

185
Chatpod
Bodenhof 4, 6014 Luzern (Switzerland)
1x2x 1x
Always carry the front panel in a way that the hinges are always on top, otherwise the door
could accidentally open and break.
Attention:
Is required in addition to the scope of delivery:

185
Chatpod
Bodenhof 4, 6014 Luzern (Switzerland)
1
1
2
23
3
4
4
1
Place the honeycomb cardboard blocks
under the cardboard supports of the
base. Make sure that the bottom sits
stably on the blocks and that the blocks
protrude a few centimenter to the sides.
2
Place the two sides on
the honeycomb blocks
and tuck them into the
bottom. This should go
easily, if not, make sure
the sides and bottom
are aligned. Hold the
sides until the top is
assembled. Pin the top
together with the sides,
pull the cable through
the top from the right
side.

Bodenhof 4, 6014 Luzern (Switzerland)
M6 x 40mm
3
Insert the six connecting rods.
4
Join the back wall with the sides, the
bottom and the top. Secure the back
panel by screwing the six screws a few
turns into the connecting rods. Do the
same with the front. Now tighten all the
screws, which must be countered on the
opposite side.

Bodenhof 4, 6014 Luzern (Switzerland)
6.3 x 70mm
6
Now screw the table to the side with
the five screws.
5
Assemble the door handle
in the following order: lock,
metal washer, plastic
washer, door handle. Press
the two halves of the door
handle together while
tightening the stud screw
with the 3 mm hex key.
Make sure that the handle
is mounted with the pre-
mounted square pin in the
inside of the
chatpod.

click
7
Remove the four honeycomb cardboard
blocks. Align the chatpod using the four
leveling feets. Insert the plug as shown.
Place the two outer panels on the cover.
Plug the power cord into the socket.
Well
done!