In 2 Care Mosquito Station User manual

Mosquito Station Installation
Note: The In2Care Mosquito Station does not immediately kill adult mosquitoes. The contents of the station therefore
may not contain high numbers of dead mosquitoes. However, the station kills the mosquito larvae that emerge from the
eggs that are laid inside the station, prior to larvae transforming into adult mosquitoes. This means that small living
larvae may be encountered in the station. The exiting adult female mosquito itself is contaminated, so that she can
carry powder to other breeding sites (in the vicinity of the station). She will be killed by the powder after a few days.
Base Lid FloaterIn2Mix package
Foruse to control Aedes species of Mosquitoes that may transmit
Zika,Chikungunya and Dengue Fever
.
.
.
Manufacturedby:
In2CareBV, Marijkeweg22,6709 PG Wageningen, NL EPAReg. No.: 91720-1, EPAEst. No.: 7319-NLD-1
a
-
NetWeight: 0.5g (0.018ounces) BatchNo:
I2CT.1.US.1001
eg.
1,E
In2Mix®
Refills forthe In2Care®Trap
R
e
FIRST AID
Contents
Assembly
Fill the base of the In2Care®
Mosquito Station with 5 quarts
(4.7 liters) of clean tap water.
Slide the plastic pin at the ending of the gauze
over the pin as shown. The hook facing inward.
Try not to touch the gauze extensively to avoid
removal of the active powders.
Foruseto control Aedes species of Mosquitoes that may transmit
Zika,Chikungunyaand Dengue Fever
.
.
.
Manufacturedby:
In2CareBV,Marijkeweg22,6709 PG Wageningen, NL
EPAReg.No.:91720 -1, EPAEst. No.: 7319-NLD-1
a
-
NetWeight: 0.5g
(0.018ounces)
BatchN
o
:
I2CT.1.US.1001
eg.
1,E
In2Mix®
Refills forthe In2Care
®
Trap
R
e
FIRSTAID
Empty the remaining contents (powder
and odor tablets) of the In2Mix package
into the water of the station. Avoiding the
gauze from getting wet.
Turn the time indicator to the
number of the current month as a
service reminder.
Place the assembled floater inside the station
by gently placing it over the central tube flat
onto the water.
Prevent the gauze from getting wet as water
will degrade the powder.
Wrap the gauze around the floater
and slide the other gauze hook on
the last pin as shown. Work your way
around moving the gauze down at
each pin.
!
Push the gauze down the pins until it
will go no further (where the bottom of
the pin hits the circular rib). The rib
will prevent the gauze from sliding too
far.
Shake the In2Mix package thoroughly
and open it by tearing at the notches.
Gently take out the powder-coated piece
of gauze.
Foruse to control Aedes species of Mosquitoes that may transmit
Zika,Chikungunya and Dengue Fever
.
.
.
Manufacturedby:
In2CareBV, Marijkeweg 22,6709 PG Wageningen, NL
EPAReg. No.: 91720-1, EPA Est. No.: 7319-NLD-1
a
-
Net Weight: 0.5g
(0.018 ounces)
Batch N
o
:
I2CT.1.US.1001
eg.
1,E
In2Mix®
Refills for the In2Care
®
Trap
R
e
FIRST AID
Place the lid on the central tube, push it down
and turn it clockwise.
1
2
Time indicator cap
!

Mosquito Station Maintenance
Remove the lid by turning it
counter clockwise until the
stop and lift it.
1
2
Re-visit each station every 4 weeks.
Placement
Place in a shady spot
Evenly distribute stations over available space
Place on a level surface
Recommendations
For an optimal efficacy of the In2Care Mosquito Station, ensure high
station coverage (1 station per 400m²/10-15 per acre) in the selected
treatment area and remove other mosquito breeding sites as much as
possible.
Remove and/or empty artificial water containers (flower pots, plastic
cups, sewage drains, septic tanks, car tires, etc.) and natural breeding
sites (puddles, tree holes etc.). Larger water bodies that cannot be
removed or emptied should be (frequently) treated with appropriate
mosquito larvicides.
We recommend outdoor station placement in shaded areas, close to
human habitation/houses.
In dry areas, check the water level inside the station regularly and add
more water when needed.
>3m / >10ft.
Remove leaves or other debris
that may have fallen into the
water and refill the station with
clean tap water.
Maintenance
Fixating
Take out the floater and
discard the used gauze.
(follow the instructions on
the In2Mix package)
3.5 - 4.5 liters
(±1 gallon)
Take a new In2Mix package
and repeat the assembly
steps as described on the
other side of this manual.
Foruse to control Aedes species of Mosquitoes that may transmit
Zika,Chikungunya and Dengue Fever
.
.
.
Manufacturedby:
In2CareBV, Marijkeweg22,6709 PG Wageningen, NL
EPAReg. No.: 91720-1, EPAEst. No.: 7319-NLD-1
a
-
NetWeight: 0.5g
(0.018ounces)
BatchNo:
I2CT.1.US.1001
eg.
1,E
In2Mix®
Refills forthe In2Care®Trap
R
e
FIRST AID
Another fixation option is to use the
holes in the rim of the base and tie
the base to a pole or tree using a zip
tie or a small rope.
The loop can be tied to a
ground pin or hook
When stations are disturbed by animals, stability can be improved by fixating the station to the ground
using a zip tie or the wire bracket, available seperately from the distributor, which snaps onto the pot.
Zip Tie spec:
width: 4.8mm
length: min. 600mm
The wire bracket can be screwed
onto a surface or fixed with a
ground pin.