Mosquito Trap Maintenance
Remove the lid by turning it
counter clockwise until the
stop and lift it.
1
2
Re-visit each trap every 4 weeks.
Placement
Place in a shady spot
Evenly distribute traps over available space
Place on a level surface
Recommendations
For an optimal efficacy of the In2Care Mosquito Trap, ensure high trap
coverage (1 trap per 400m²/10-15 per acre) in the selected treatment
area and remove other mosquito breeding sites as much as possible.
Remove and/or empty artificial water containers (flower pots, plastic
cups, sewage drains, septic tanks, car tires, etc.) and natural breeding
sites (puddles, tree holes etc.). Larger water bodies that cannot be
removed or emptied should be (frequently) treated with appropriate
mosquito larvicides.
We recommend outdoor trap placement in shaded areas, close to
human habitation/houses.
In dry areas, check the water level inside the trap regularly and add
more water when needed.
>3m / >10ft.
Remove leaves or other debris
that may have fallen into the
water and refill the trap with
clean tap water.
Maintenance
Fixating
Take out the floater and
discard the used gauze.
(follow the instructions on
the refill package)
3.5 - 4.5 liters
(±1 gallon)
Take a new refill package
and repeat the assembly
steps as described on the
other side of this manual.
Foruse to control Aedes species of Mosquitoes that may transmit
Zika,Chikungunya and Dengue Fever
.
.
.
Manufacturedby:
In2CareBV,Marijkeweg 22,6709 PG Wageningen, NL
EPAReg. No.: 91720-1, EPAEst. No.: 7319-NLD-1
a
-
NetWeight: 0.5g
(0.018ounces)
BatchNo:
I2CT.1.US.1001
In2Mix®
Refills forthe In2Care® Trap
Another fixation option is to use the
holes in the rim of the pot and tie the
pot to a pole or tree using a zip tie or
a small rope.
The loop can be tied to a
ground pin or hook
When traps are disturbed by animals, stability can be improved by fixating the trap to the ground
using a zip tie or the wire bracket, available seperately from the distributor, which snaps onto the pot.
Zip Tie spec:
width: 4.8mm
length: min. 600mm
The wire bracket can be screwed
onto a surface or fixed with a
ground pin.