Indesit BIA series User manual

COOLING
Service Quick Guide
Service Quick Guide
Indesit Company, Service Department
Refrigerators: “BIA... and FFFM... and BIAA.... and IB... and EBM...”
Models Covered:
Interface:
THR3 No Frost Platform (Electronic Thermostat)
1/2
The knob is used to switch the appliance on and off
and to adjust the freezer compartment temperature.
The fridge compartment temperature is controlled by
a mechanical damper on the multiflow unit
Autotest:
AUTOTEST ACTIVATION:
The function is activated by turning the knob on the control
panel quickly from OFF to the maximum setting and then
back to OFF.
AUTOTEST DEACTIVATION:
The appliance can exit the Autotest procedure 3 different
ways:
1. After 255 seconds (duration of procedure)
2. By switching on the appliance (using the control knob)
3. By unplugging the appliance from the mains
SQG_CL_32_EN
Demo Mode:
This product does not feature DEMO MODE.

Procedura Autotest:
For 10 seconds, activation of FZ fan, defrost heating element and fridge light.
All loads off for 3 seconds.
Probe Check
If one of the two probes has a fault, the fridge light flashes for 5 seconds (1 second ON and 1
second OFF)
If everything is OK and there are no probe faults, the fridge light remains ON for 5 seconds.
All loads off for 3 seconds.
Defrost Heating Element Check
If there is a defrost heating element fault, the fridge light flashes for 5 seconds (1 second ON
and 1 second OFF).
If everything is OK and there is no defrost heating element fault, the fridge light remains ON
for 5 seconds.
All loads off for 3 seconds.
Electronic Board Check
If there is an electronic board fault, the fridge light flashes for 5 seconds (1 second ON and 1
second OFF).
If everything is OK and there is no electronic board fault, the fridge light remains ON for 5
seconds.
All loads off for 3 seconds.
Pause for 7 seconds.
Fridge Air Probe Check
If there is a fault relating to the FZ air probe, the fridge light flashes for 5 seconds (1 second
ON and 1 second OFF).
If everything is OK and there is no FZ air probe fault, the fridge light remains ON for 5 seconds.
All loads off for 3 seconds.
FZ Evaporator Probe Check
If there is a fault relating to the FZ evaporator probe, the fridge light flashes for 5 seconds (1
second ON and 1 second OFF).
If everything is OK and there is no FZ evaporator probe fault, the fridge light remains ON for 5
seconds.
All loads off for 3 seconds.
Activation of FZ fan and defrost heating element for 217 seconds.
THR3 No Frost Platform (Electronic Thermostat)
2/2