Infatrac Emergency Call Box User manual

[phone]
[e-mail]
www.infatrac.com
Emergency Call Box
Quick Start Guide
Rev. A
Issue Date: 06232016
Document Number: 0011
UNPACKING INSTRUCTIONS
Your Emergency Call Box (ECB) should contain the
following components:
Emergency Call Box (ECB)
7-21vDC barrel plug to terminal block
Small Elbow Antenna
USB to Mini USB Programming Cable
RJ11 Phone Line
The following are sold separately
AC Power Supply
Extended Antenna
Signal Boosters
Figure 1: Rear Panel
Figure 2: Front Panel
SET UP INSTRUCTIONS
1. Connect the Power Plug to the MS130 DC12V
Power Port. Connect the Phone to the Phone Line
Port.(See the Figure 3)
2. Attach the Antenna to the exposed ANT Port.
3. Connect the other end of the Phone and Power
Cables.
Figure 3: MS130 Installation Setup Diagram
Professional Installation Recommended. Basic security
system installation skills are required. If you would like us
to professionally install your MS130, please contact us.

[phone]
[e-mail]
www.infatrac.com
ACTIVATION INSTRUCTIONS
1. To activate your ECB, contact Infatrac by calling our
toll free number 877-262-6593. You may be asked
for your ECB’s MEID and Serial Number (S/N). You
can find these numbers on label located on the
bottom of your ECB.
Figure 5: MEID and S/N
2. To register your ECB, please visit
infatrac.com/registration-portal.html and fill out the
accompanying questionnaire.
3. To verify that your device has been activated, the
Internet Status LED (see table on HARDWARE
STATUS LEDs) should be lit. If it is not lit, please
contact customer support.
FCC COMPLIANCE STATEMENT
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
You may also find helpful the following booklet, prepared by the FCC:
"How to Identify and Resolve Radio-TV Interference Problems." This
booklet is available from the U.S. Government Printing Office,
Washington D.C. 20402.
Changes and Modifications not expressly approved by the manufacturer
or registrant of this equipment can void your authority to operate this
equipment under Federal Communications Commission’s rules.
HARDWARE STATUS LED’S
LED
ICON
COLOR
STATE
DESCRIPTION
1
POWER
STATUS
GREEN
ON
POWER ON
-
OFF
POWER OFF
2
SERVER
STATUS
GREEN
ON
CARRIER READY
-
FLASHING
CHECK WITH
CARRIER
3
INTERNET
STATUS
GREEN
ON
INTERNET “ON”
-
OFF
INTERNET “OFF
”
4
SIGNAL
STATUS
GREEN
ON
WEAK SIGNAL
FLASHING
OFF
NO SIGNAL
5
SIGNAL
STATUS
GREEN
ON
STRONG SIGNAL
-
FLASHING
OFF
MEDIUM SIGNAL
6
HARDWARE
STATUS
GREEN
ON
ACTIVATED READY
-
Flashing
CERTIFICATING
-
OFF
RE-TRY
ACTIVATION
PROCEDURE
ADDITIONAL INFORMATION
Complete User Manual can be found at:
https://www.infatrac.com/ emergency-call-box--ecb-.html