Inficon IRwin S User manual

How to Set your IRwin Methane Leak Detector for
1 Point Calibration 500ppm (Universal Mode)
(for a factory set unit)
QUICK START GUIDE
1 of 5
1
Make sure your IRwin is set in Universal Mode (see
the How to set your IRwin for Universal Mode quick
start guide)
Use to navigate to General and press
2
3
4
5
Press followed by
Use to navigate to AbG Cal Setup and press
mimb66en1-01 (1905)
Use to navigate to Custom and press

How to Set your IRwin Methane Leak Detector
for 1 Point Calibration 500ppm
6
Use to select Generic and press
7
Press
8
9
2 of 5 mimd66en1-01 (1905)
Use and to navigate to Calibration
and press
Use to navigate to Settings and press
10
If prompted, enter the (min) Intermediate password code and press .
If not prompted, go ahead to next step

11
How to Set your IRwin Methane Leak Detector
for 1 Point Calibration 500ppm
3 of 5 mimd66en1-01 (1905)
Press to get to the drop-down menu
12
Press on the rst choice of the drop-down
menu
13
Navigate to far right drop-down menu and press
14
Use to select Disabled and press
15
Press again to view drop-down menu

16
How to Set your IRwin Methane Leak Detector
for 1 Point Calibration 500ppm
Navigate to the second choice in the drop-down
menu and press
17
Use to navigate the drop-down menus.
Enter:
5 and press
0 and press
0 and press
18
Navigate to far right drop-down menu and press
19
Select Set and press
4 of 5 mimd66en1-01 (1905)
20
Press again to view the drop-down menu

www.inficon.com [email protected]
Due to our continuing program of product improvements, specifications are subject to change without notice.
All trademarks are the property of the ir respective owners.
©2019 INFICON mimd66en1-01 (1905)
How to Set your IRwin Methane Leak Detector
for 1 Point Calibration 500ppm
21
Select the third choice in the drop-down menu and
press
22
23
Select Disabled and press
Navigate to far right drop-down menu and press