Infinity Drain LTD-5 Series User manual

LTD-5 Series LTD-5 Installation
Infinity Drain recommends this product be
installed by a licensed contractor
1. Determine clamp down drain
(C) location. Connect to drain pipe.
2. Create a pre-slope in four directions
towards drain body (C). Waterproof
to local code.
3. Insert bottom frame (B) into clamp
down drain (C) and adjust height
as needed.
4. Remove top frame (A) and install
tile within frame, using mortar and
thin set.
5. Finish floor must be 1/16″ higher
than top edge of bottom frame (B).
Installation Instructions
Figure 1
Determining floor height
Finished floor height must be 1/16″ higher at top edge of Infinity Drain
Minimum height
≈ 3/4″
Maximum height
≈ 2⅛″
Figure 2
LTD-5
18 Secatoag Avenue, Port Washington, New York 11050 ● p:516.767.6786 f:516.740.3066 www.infinitydrain.com
Parts List
(C) Fits standard
size residential
drains in Cast Iron,
ABS or PVC.
Weep holes
Waterproofing
membrane
(A) Top frame
(B) Bottom frame

LT5 Series LT5 Installation
Infinity Drain recommends this product be
installed by a licensed contractor
1. Determine clamp down drain
(C) location. Connect to drain pipe.
2. Create a pre-slope in four directions
towards drain body (C). Waterproof
to local code.
3. Insert bottom frame (B) into clamp
down drain (C) and adjust height
as needed. Allow secondary mortar
bed to support bottom frame (B).
4. Remove top frame (A) and install
tile within frame, using mortar and
thin set.
5. Finish floor must be 1/16″ higher
than top edge of bottom frame (B).
Installation Instructions
Figure 1
Determining floor height
Finished floor height must be 1/16″ higher at top edge of Infinity Drain
Minimum height
≈ 1⅞″
Maximum height
≈ 2¾″
Figure 2
18 Secatoag Avenue, Port Washington, New York 11050 ● p:516.767.6786 f:516.740.3066 www.infinitydrain.com
Parts List
(C) Fits standard
size residential
drains in Cast Iron,
ABS or PVC.
Weep holes
Waterproofing
membrane
(A) Top frame
(B) Bottom frame
1"
1¾"
2"
Fits standard residential drain