Infinity TOTAL SPEAKER SOLUTIONS TSS-STAND4000 User manual

TSS-STAND4000
Owner’s Guide
TOTAL SPEAKER SOLUTIONS
TSS-4000
INFP1596Stand4000-OM 10/18/04 2:51 PM Page 1

Satellite Speaker
Infinity Logo
End Cap
1/4-20 x 3/4" Screw
Installing theTSS-SAT4000
Step One
Remove the bottom end cap of the speaker by unscrewing the
single center screw (Allen wrench included with satellite).
StepThree
Align and insert the alignment pin into the bottom of the speaker.
StepTwo
Attach alignment pin to stand, and run speaker wire up stand.
NOTE: Needle-nose pliers may be required. Alignment Pin
NOTE: The bottom is the side
closest to the Infinity logo on
the front grille.
Alignment Pin
INFP1596Stand4000-OM 10/18/04 2:51 PM Page 2

Step Four
Tighten the bolts on the bottom as shown. It’s recommended that
two people perform this step so that the speaker is supported
while it’s on its side and the bolts are being tightened.Attach
speaker wire as described in TSS-SAT4000 Owner’s Manual.
Bolts
25"
47-1/2"
INFP1596Stand4000-OM 10/18/04 2:51 PM Page 3

© 2004 Harman International Industries, Incorporated
Infinity Systems,250 Crossways Park Drive,Woodbury, NY 11797 USA 516.674.4INF (USA only) www.infinitysystems.com
Infinity is a registered trademark,andTotal Solutions is a trademark, of Harman International Industries, Incorporated. Part No.400-OMSTN 10/04
INFP1596Stand4000-OM 10/18/04 2:51 PM Page 4