
On/Off Switch – Press once to turn on when device is off. Make sure
the power switch on the back is turned on. Press for 5 seconds to
gracefully shutdown device. Always use the On/Off switch to turn off
system when possible to avoid data loss.
Status LED – Blinks slowly, about once every 4 seconds, during boot.
LED becomes solid then the system is ready. A disk fault in the system
will blink this LED at a faster rate, about once a second.
Disk LEDs – Blinks green for normal disk activity. Solid amber for disk
failure.
Power Switch – Controls AC power to the ReadyNAS. Use the
On/Off switch in the front to turn system off gracefully to avoid data loss.
Power Connector – When Power Switch is in the On position,
attaching the power cable will automatically turn on the ReadyNAS. This
enables the ReadyNAS to boot up in the event that power returns after a
power-failure.
MAC Address – The MAC address assigned to the Ethernet interface.
Use the MAC address to identify this system in RAIDar listing.
Ethernet Ports – Auto-switching 10/100/1000. Use a Cat-5 network
cable to connect to your network.
USB Ports - The ReadyNAS supports USB printer, UPS, and wireless
network adapters.
System Reset Switch – Depressing this switch for 30 seconds while
powering up the system will set the system back to factory default state.
See "System Reset Switch" chapter in ReadyNAS User Guide for details.
Infrant Technologies Inc.
3065 Skyway Ct, Fremont, CA 94539 USA
001 (510) 438-7982
Website: www.infrant.com
© 2004 Infrant Technologies, Inc. All rights reserved.
READYNAS and FrontView are trademarks of Infrant Technologies, Inc.
ll other product names are the properties of their respective owner.
Printed in U.S.A. P/N: IT-05-1-1060-U-01