inGarden KneeGuardKids 3 INNO SENSE User manual

We are proud of you preparing
for your beloved kids instead of some pretty clothes.
MUST HAVE
MUST HAVE
Instruction
Video
KneeGuardKids 3 Instruction Manual

Warning
· This product is not designed to protect against shock caused by a car crash.
· This product is designed to be a footrest and should be used as such.
· Do not stand on the footrest or use as a step to get into the car seat.
Caution
· Cannot be used for car seats with a Load Leg.
· Can be used when detaching a Load (support) Leg
· Please contact our customer care center for details
before unpacking this product.
Box Contents
※ Please ensure below contents before using.
※ Assembled the Height Control Bar and the Load Leg is included.
1 Installing Plate 1 Foot Plate 1 Height Control Bar 1 Load Leg
2 ISOFIX Hooks 2 Installing Clips 2 Belts 1 Instruction Manual
Load Leg
2

Name of Each Part
Foot Plate Dimensions : Length 37cm, Width 22cm
To use KneeGuardKids 3, you need to have the space at least 22cm.
Install with the Clips for cars without ISOFIX
instead of the ISOFIX Hooks
Installing Plate
Height Control Lever
of Installing Plate
Angle Control
Switches
Foot Plate
Height Control Bar
ISOFIX Hooks Belts
Installing Clips
Height Control Lever
of Load Leg
Load(support) Leg
Height Control Lever
of Foot Plate
Bottom Plate of
Load Leg
3

For Infant & Convertible Car Seat (Ages 3 and under)
Assemble the Installing Plate first and then the Foot Plate.
Otherwise, infant legs may not reach the Foot Plate.
Assembling Method
STEP 2. Assemble the Foot Plate
Lift the Lever of Foot Plate Pushing the button (protrusion)
of the Foot Plate hole inside, join
the Foot Plate and the Height
Control Bar
Place the Foot Plate on top of the
Height Control Bar and then pull
down the Lever
※InstallwiththeClipsforcarswithoutISOFIXinsteadoftheISOFIXHooks
PleaserefertoSTEP3onpage5foradetailedattachingmethodoftheClips
STEP 3. Attaching the Belts with ISOFIX Hooks (Cars with ISOFIX)
Insert the Belt to hole in the back of
the Installing Plate from bottom
to top.
Insert the Belt into the length
adjustable buckle.
(※ Please follow the steps as
described
in the above picture.)
(※YoucanpulldowntheHeightControlLeverbyusingslightupanddownmovementstomatchthegrooveandunevensurface.)
Lift the Lever of Installing Plate
STEP 1. Assemble the Installing Plate
Pushing the button (protrusion) of
the Installing Plate hole inside, join
the Installing Plate and the Height
Control Bar.
4
Place the Installing Plate in the
middle of the Height Control Bar
and then pull down the Lever
Holding the Belt with engraved
logo side, insert the Belt to the
ISOFIX Hook from top to bottom
1
2

Insert the Belt into the length
adjustable buckle.
(※ Please follow the steps as described
in the above picture.)
Holding the Belt with engraved
logo side, insert it into the top hole of
the Installing Clip, and then pull
it out again through the bottom
hole
For Booster & Junior Car Seat (Ages 4 and over)
Assemble the Foot Plate first and then Installing Plate after.
STEP 2. Assemble the Installing Plate
Lift the Lever of Installing Plate
Pushing the button (protrusion) of
the Installing Plate hole inside,
join the Installing Plate and the
Height Control Bar.
Place the Installing Plate on top of
the Height Control Bar and then pull
down the Lever.
※InstallwiththeHooksforCarswithISOFIXinsteadoftheClips
PleaserefertoSTEP3onpage4foradetailedattachingmethodoftheHooks
STEP 3. Attaching the Belts with Installing CLIPS (Cars without ISOFIX)
Insert the Belt to hole in the
back of the Installing Plate from
bottom to top.
Insert the Belt into the length
adjustable buckle.
(※ Please follow the steps as
described in the above picture.)
(※YoucanpulldowntheHeightControlLeverbyusingslightupanddownmovementstomatchthegrooveandunevensurface.)
Lift the Lever of Foot Plate
STEP 1. Assemble the Foot Plate
Place the Foot Plate in the middle of the
Height Control Bar and then pull down
the Lever
Pushing the button (protrusion) of
the Foot Plate hole inside, join the
Foot Plate and the Height Control
Bar
5
1
2

Cars without ISOFIX (Install with Clips)
Hold the Installing Clips horizontally
facing upside.
Insert the Installing Clips into the
gap as shown while keeping its
face downward.
Push the Installing Clips horizon-
tally all the way and then push
and stand the Clips vertically.
(※ If you cannot stand the Clips
vertically, push the Installing Clips
further downward.)
Place the Height Control Bar close to
the vehicle seat and then fasten the
Belts.
(※ If the Height Control Bar is not
firmly contacted to the vehicle
seat, the Foot Plate may shake.)
After install the car seat on the
Installing Plate, adjust height of
the Foot Plate and the Load Leg for
the comfort level of your kid.
(※ Please refer to page7 for a
detailed
height adjustment method.)
Hang the ISOFIX Hooks from top
to bottom on the ISOFIX LATCH.
Cars with ISOFIX (Install with ISOFIX Hooks)
Installing Method
as close
as possible
6
as close
as possible
Insert your hand in the gap(seat
bight)between the cushion and
the back of the vehicle seat to
check if there isenough room for
the Installing Clips
(※ Safety first , make sure your
hand is safe.)
Place the Height Control Bar close to
the vehicle seat and then fasten the
Belts.
(※ If the Height Control Bar is
not
firmly contacted to the vehicle
seat, the Foot Plate may shake.)
After install the car seat on the
Installing Plate, adjust height of
the Foot Plate and the Load Leg for
the comfort level of your kid.
(※ Please refer to page7 for a
detailed height adjustment method)

Push both of the Angle Control
Switches outward.
For Booster & Junior Car Seat (Ages 4 and over)
※ Caution
If your vehicle’s seat is lower than
others, assemble the Installing
Plate to low position of the Height
Control Bar.
Place the kid on the car seat and lift
the Lever of Foot Plate. Adjust
height of the Foot Plate to match
the feet of the kid and then pull
down the Lever.
After release the Switches at
desired angle, gently shake the
Foot Plate up and down so that
the Switches return to its original
posit ion.
The sole is inclined by about 40
degrees, so it is more comfortable
for infants to adjust angle of the
Foot Plate to 40 degrees.
For Infant & Convertible Car Seat (Ages 3 and under)
Height Adjustment Method
Angle Adjustment Method
7
Lift the Lever of Load Leg. Adjust
the height of Load Leg to reach
the floor of the vehicle and then
pull down the Lever
40˚
Place the kid on the car seat and lift
the Lever of Installing Plate.
Lift the Lever of Load Leg. Adjust
the height of Load Leg to reach
the floor of the vehicle and then
pull down the Lever
Adjust height of the Foot Plate to
match the feet of the kid and then pull
down the Lever.

· Product: Car Seat Footrest
· Model: KneeGuardKids 3 INNO SENSE
· Recommended Age: 9 years and under (less than 30kg)
· Dimensions: Installing Plate 360 × 133 × 35 / Foot Plate 367 × 215 × 40
Height Control Bar 74 × 74 × 283 / Load Leg 74 × 80 × 287 (mm)
· Weight: 1.2 kg
· Materials: ABS, PP, PC
· Month of Launching: March, 2017
· Manufacture: inGarden Corporation
· Country of Origin: South Korea
About the Product
· Mount firmly and securely using the ISOFIX Hooks or Installing Clips.
· Board the vehicle after fully folding the Foot Plate and use it after unfolding them.
· Do not stand on the footrest or use as a step to get into the car seat.
· Height and angle adjustment should be made by an adult when the vehicle is not in motion.
· Remove them when not in use for a long time and keep them separately.
· When it is dirty, please clean it with a gentle detergent
· This product was manufactured under strict quality control process.
· The 6 month warranty for KneeGuardKids 3 begins on the date of purchase.
? Warranty claims can be sent to [e-mail]
· During the warranty period, defective products will be A/S or replaced free of charge.
· Damage caused by the customer, normal loss of parts will not be A/S or replaced free of charge
even during the warranty period.
· Customer Center: ☎ [phone] / [e-mail]
inGarden Corporation
#520, Cheonggye Tower, 53, Seonggogae-ro,
Uiwang-si, Gyeonggi-do, 16006, South Korea
TEL [phone]ㅣFAX [phone]ㅣE-MAIL [email protected]t
Cautions
Warranty
www.kneeguardkids.com